An analytical solution for shear bearing capacity of circumferential joints of precast concrete segmental tunnel linings considering dowel action

The capacity of the circumferential joint of the precast concrete segmental tunnel lining (PCTL) structure in terms of shear performance principally includes the dowel action by connector/bolt as well as friction force, and it is a vital parameter to assess the mechanical response of the circumferential joint. Further, as there was no analytical model available for precise estimation of a circumferential joint in terms of the shear‐bearing capacity considering the dowel action of the bolt in the presence of axial/normal force, therefore in this investigation, an analytical model has been proposed to estimate the shear‐bearing capacity of the circumferential joint. Furthermore, the analytical model's precision and accuracy were validated via large‐scale experimental investigation on a circumferential joint of PCTL. Upon comparing analytical model outcomes with experimental results, absolute error varied between +5% and −9%, with an average value of the coefficient of friction at the yield point of the bolt. Moreover, the formation of hinges on the side of the bolt within the segment was considered a failure of the circumferential joint. Additionally, the parametric investigation revealed that with just a 1% change in axial force, the diameter, pre‐tightening, and yield strength of the bolt and concrete strength improved by 2.85%, 1%, 0.27%, 0.26% and 0.17% shear‐bearing capacity of the circumferential joint respectively. Axial force variation greatly influences the shear‐bearing capacity of circumferential joint followed by diameter, pre‐tightening, yield strength of the bolt, and concrete strength. Conclusively, with analysis of axial force distribution around the ring for the tunnel, the proposed model has been applied to a full ring to estimate shear bearing capacity.