Seismic behavior of plate‐reinforced composite coupling beams with steel bar truss deck

SummaryTo better meet the evolving requirements of industrialized building system, this paper introduces a novel approach by proposing the utilization of a plate‐reinforced composite (PRC) coupling beam, which incorporates a steel bar truss deck as a substitute for the conventional reinforced concrete (RC) slab. In order to study the effect of different types of RC slabs on the performance of PRC coupling beams, the low‐cyclic reversed loading test was carried out on three PRC coupling beams. The differences of failure modes, load bearing capacity, stiffness degradation, and energy dissipation capacity of each coupling beam are analyzed. The finite element software ABAQUS is used to analyze the stress distribution in the concrete, steel plate, and reinforcement skeleton of the novel coupling beam. The results show that the incorporation of a steel bar truss deck in PRC coupling beams with a small span‐to‐depth ratio can effectively enhance their shear bearing capacity and energy dissipation capacity. The inclusion of a slab significantly enhances the load‐bearing capacity of the coupling beam, while the utilization of a steel bar truss deck in PRC coupling beams greatly improves their overall bearing capacity. The PRC coupling beams featuring a steel bar truss deck exhibit superior load capacity compared to those with conventional RC slabs. The cumulative energy dissipation at the damage point in PRC beams with a steel bar truss deck is 1.39 times greater than that of the coupling beam without slabs and 1.18 times higher than that of the coupling beam with traditional RC slabs.