DESIGN AND OPTIMIZATION OF ESCITALOPRAM OXALATE ORAL DISSOLVING FILMS BY RESPONSE SURFACE METHODOLOGY

Objective: To develop and optimise the oral dissolving films of escitalopram oxalate by response surface methodology. Methods: Oral dissolving film compositions were optimized by central composite design. The films are prepared by solvent casting method. Initially, different polymers were screened and based on the results polyvinyl alcohol was selected as polymer, propylene glycol was selected as plasticizer. Concentration of polymer and concentration of plasticizer were fixed as independent variables; tensile strength, percent elongation, elastic modulus and amount dissolved up to 5 min (%D5 min) were taken as responses. Results: The prepared films exhibited good surface characteristics. The thickness, uniformity of weight, surface pH and drug content are within acceptable range. The mechanical properties like tensile strength, folding endurance, percent elongation and elastic modulus were determined. The statistical analysis showed that polymer concentration has a positive effect on disintegration time and the plasticizer concentration has a significant effect on folding endurance. The prepared film relesases nearly 95% at the end of 5 min. The design space was used to optimize the quantities of polymer and plasticizer. The comparison of checkpoint experiment batch responses are corelating with the predicted responses. Conclusion: Escitalopram oxalate oral dissolving films was successfully designed and optimized by response surface method. It was concluded that the prepared films exhibit good mechanical properties and maximum release within 10 min.