开发基于能量的实验方法,用于估算钛合金疲劳裂纹的演变

IF 1.8 4区 材料科学 Q2 MATERIALS SCIENCE, CHARACTERIZATION & TESTING
A. Yu. Iziumova, A. N. Vshivkov, O. A. Plekhov
{"title":"开发基于能量的实验方法,用于估算钛合金疲劳裂纹的演变","authors":"A. Yu. Iziumova,&nbsp;A. N. Vshivkov,&nbsp;O. A. Plekhov","doi":"10.1134/S1029959924010041","DOIUrl":null,"url":null,"abstract":"<p>This paper presents an experimental study of energy dissipation caused by fatigue crack growth in Grade 2 titanium and titanium alloys Ti-1.1Al-0.9Mn and Ti-4.6Al-1.77V using the original heat flux method. It is shown that significant structural changes occur in the material under plastic deformation, leading to internal energy evolution. As is known, a large part of the deformation energy is dissipated as heat. The developed method allows high-accuracy measurements of the heat flux caused by plastic zone development at the crack tip directly in the fatigue experiment. Simultaneous measurements of the crack length and displacements in the stress concentration zone allow estimating the energy balance of the tested specimens. Analysis of the obtained data confirms that the stored strain energy reflecting the structural state of the material can be used as a fracture criterion. Based on the heat flux data, a kinetic equation is derived for predicting the rate of fatigue crack growth under Paris’s law by the energy dissipation rate.</p>","PeriodicalId":726,"journal":{"name":"Physical Mesomechanics","volume":"27 1","pages":"41 - 48"},"PeriodicalIF":1.8000,"publicationDate":"2024-02-08","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"0","resultStr":"{\"title\":\"Development of an Energy-Based Experimental Method for Estimation of Fatigue Crack Evolution in Titanium Alloys\",\"authors\":\"A. Yu. Iziumova,&nbsp;A. N. Vshivkov,&nbsp;O. A. Plekhov\",\"doi\":\"10.1134/S1029959924010041\",\"DOIUrl\":null,\"url\":null,\"abstract\":\"<p>This paper presents an experimental study of energy dissipation caused by fatigue crack growth in Grade 2 titanium and titanium alloys Ti-1.1Al-0.9Mn and Ti-4.6Al-1.77V using the original heat flux method. It is shown that significant structural changes occur in the material under plastic deformation, leading to internal energy evolution. As is known, a large part of the deformation energy is dissipated as heat. The developed method allows high-accuracy measurements of the heat flux caused by plastic zone development at the crack tip directly in the fatigue experiment. Simultaneous measurements of the crack length and displacements in the stress concentration zone allow estimating the energy balance of the tested specimens. Analysis of the obtained data confirms that the stored strain energy reflecting the structural state of the material can be used as a fracture criterion. Based on the heat flux data, a kinetic equation is derived for predicting the rate of fatigue crack growth under Paris’s law by the energy dissipation rate.</p>\",\"PeriodicalId\":726,\"journal\":{\"name\":\"Physical Mesomechanics\",\"volume\":\"27 1\",\"pages\":\"41 - 48\"},\"PeriodicalIF\":1.8000,\"publicationDate\":\"2024-02-08\",\"publicationTypes\":\"Journal Article\",\"fieldsOfStudy\":null,\"isOpenAccess\":false,\"openAccessPdf\":\"\",\"citationCount\":\"0\",\"resultStr\":null,\"platform\":\"Semanticscholar\",\"paperid\":null,\"PeriodicalName\":\"Physical Mesomechanics\",\"FirstCategoryId\":\"88\",\"ListUrlMain\":\"https://link.springer.com/article/10.1134/S1029959924010041\",\"RegionNum\":4,\"RegionCategory\":\"材料科学\",\"ArticlePicture\":[],\"TitleCN\":null,\"AbstractTextCN\":null,\"PMCID\":null,\"EPubDate\":\"\",\"PubModel\":\"\",\"JCR\":\"Q2\",\"JCRName\":\"MATERIALS SCIENCE, CHARACTERIZATION & TESTING\",\"Score\":null,\"Total\":0}","platform":"Semanticscholar","paperid":null,"PeriodicalName":"Physical Mesomechanics","FirstCategoryId":"88","ListUrlMain":"https://link.springer.com/article/10.1134/S1029959924010041","RegionNum":4,"RegionCategory":"材料科学","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q2","JCRName":"MATERIALS SCIENCE, CHARACTERIZATION & TESTING","Score":null,"Total":0}
引用次数: 0

摘要

摘要 本文采用原始热通量法对 2 级钛和钛合金 Ti-1.1Al-0.9Mn 和 Ti-4.6Al-1.77V 中疲劳裂纹生长引起的能量耗散进行了实验研究。结果表明,材料在塑性变形下会发生重大结构变化,导致内能演变。众所周知,变形能量的很大一部分以热量的形式耗散。所开发的方法可在疲劳实验中直接对裂纹尖端塑性区发展所产生的热通量进行高精度测量。同时测量应力集中区的裂纹长度和位移,可以估算出测试试样的能量平衡。对所获数据的分析证实,反映材料结构状态的存储应变能可用作断裂标准。根据热通量数据,推导出一个动力学方程,通过能量耗散率来预测帕里斯定律下的疲劳裂纹增长速度。
本文章由计算机程序翻译,如有差异,请以英文原文为准。

Development of an Energy-Based Experimental Method for Estimation of Fatigue Crack Evolution in Titanium Alloys

Development of an Energy-Based Experimental Method for Estimation of Fatigue Crack Evolution in Titanium Alloys

This paper presents an experimental study of energy dissipation caused by fatigue crack growth in Grade 2 titanium and titanium alloys Ti-1.1Al-0.9Mn and Ti-4.6Al-1.77V using the original heat flux method. It is shown that significant structural changes occur in the material under plastic deformation, leading to internal energy evolution. As is known, a large part of the deformation energy is dissipated as heat. The developed method allows high-accuracy measurements of the heat flux caused by plastic zone development at the crack tip directly in the fatigue experiment. Simultaneous measurements of the crack length and displacements in the stress concentration zone allow estimating the energy balance of the tested specimens. Analysis of the obtained data confirms that the stored strain energy reflecting the structural state of the material can be used as a fracture criterion. Based on the heat flux data, a kinetic equation is derived for predicting the rate of fatigue crack growth under Paris’s law by the energy dissipation rate.

求助全文
通过发布文献求助,成功后即可免费获取论文全文。 去求助
来源期刊
Physical Mesomechanics
Physical Mesomechanics Materials Science-General Materials Science
CiteScore
3.50
自引率
18.80%
发文量
48
期刊介绍: The journal provides an international medium for the publication of theoretical and experimental studies and reviews related in the physical mesomechanics and also solid-state physics, mechanics, materials science, geodynamics, non-destructive testing and in a large number of other fields where the physical mesomechanics may be used extensively. Papers dealing with the processing, characterization, structure and physical properties and computational aspects of the mesomechanics of heterogeneous media, fracture mesomechanics, physical mesomechanics of materials, mesomechanics applications for geodynamics and tectonics, mesomechanics of smart materials and materials for electronics, non-destructive testing are viewed as suitable for publication.
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
确定
请完成安全验证×
copy
已复制链接
快去分享给好友吧!
我知道了
右上角分享
点击右上角分享
0
联系我们:info@booksci.cn Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。 Copyright © 2023 布克学术 All rights reserved.
京ICP备2023020795号-1
ghs 京公网安备 11010802042870号
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术官方微信