Design of BJT-JFET Operational Amplifiers on the Master Slice Array

The use of dual-gate field-effect transistors located on the base matrix crystal MH2XA031, controlled by a p–n junction needed to reduce the input current of operational amplifiers is studied. Typical circuits of operational amplifiers, containing: source repeaters connected to the inputs of the operational amplifier on complementary bipolar transistors; input differential stage on p-JFET with a “current mirror” load on n–p–n-transistors; input differential in the form of a “folded cascode” on a p-JFET are analyzed. To minimize the input current, it is re commended to use bootstrapped feedback to keep the drain-to-source voltage of the input JFETs low, independent of the input common-mode voltage, and to connect only the top gate of the dual-gate JFET to the op-amp input. The electrical circuits for MH2XA031 elements and the results of circuit simulation of the developed amplifiers, called OAmp10J, OAmp11.1, OAmp11.2, are presented. Accounting the established features of the input stages and operating modes of active elements in circuit design will allow to create an operational amplifier with the required combination of basic parameters.