Overview on FRB Pre-Stressed Tendons and its Fatigue Behavior

Although a variety of techniques can be used to manufacture FRP shapes, a technique called pultrusion is used almost exclusively for the manufacture of FRP reinforcing rods. In this technique, continuous strands of the fibres are drawn from creels (spools of fibres) through a resin tank, where they are saturated with resin, pulled through several wiper rings, and finally pulled through a heated die. This process simultaneously forms, and heat cures the FRP into a reinforcing rod. To ensure a strong bond with concrete, a surface treatment is applied consisting of a spiral, or a braided wrap, or a coating of sand embedded in the outer surface of the polymer matrix [1]. The pultrusion process is illustrated schematically at (Figure 1). *Corresponding author: Ahmed I Hassanin, Faculty of Engineering, Egyptian Russian University, Cairo, Egypt. Received Date: March 07, 2019 Published Date: May 28, 2019 ISSN: 2692-5397 DOI: 10.33552/MCMS.2020.01.000510