级联开关稳压器的直流IR降稳态估计

Robin Sercu, H. Barnes
{"title":"级联开关稳压器的直流IR降稳态估计","authors":"Robin Sercu, H. Barnes","doi":"10.1109/SPI57109.2023.10145542","DOIUrl":null,"url":null,"abstract":"Calculating the DC IR drop for a power distribution network with cascaded dc-dc converters presents some unique challenges. The buck regulator dc-dc converters have a very dynamic large signal switching behavior that is load dependent and must be averaged to DC for the DC IR drop calculation. When cascading multiple regulators in series, the downstream regulator acts as the load for the upstream regulator. An iterative approach can be used to calculate the state of the final regulator stage for a given sink load, and then use this regulator's input current as the sink for the calculation of the DC state of the upstream regulator. This iterative approach with a simplified model for the DC regulator can be as much as $40\\mathrm{x}$ faster than solving in the transient domain.","PeriodicalId":281134,"journal":{"name":"2023 IEEE 27th Workshop on Signal and Power Integrity (SPI)","volume":null,"pages":null},"PeriodicalIF":0.0000,"publicationDate":"2023-05-07","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"0","resultStr":"{\"title\":\"DC IR Drop Steady State Estimate for Cascaded Switching Regulators\",\"authors\":\"Robin Sercu, H. Barnes\",\"doi\":\"10.1109/SPI57109.2023.10145542\",\"DOIUrl\":null,\"url\":null,\"abstract\":\"Calculating the DC IR drop for a power distribution network with cascaded dc-dc converters presents some unique challenges. The buck regulator dc-dc converters have a very dynamic large signal switching behavior that is load dependent and must be averaged to DC for the DC IR drop calculation. When cascading multiple regulators in series, the downstream regulator acts as the load for the upstream regulator. An iterative approach can be used to calculate the state of the final regulator stage for a given sink load, and then use this regulator's input current as the sink for the calculation of the DC state of the upstream regulator. This iterative approach with a simplified model for the DC regulator can be as much as $40\\\\mathrm{x}$ faster than solving in the transient domain.\",\"PeriodicalId\":281134,\"journal\":{\"name\":\"2023 IEEE 27th Workshop on Signal and Power Integrity (SPI)\",\"volume\":null,\"pages\":null},\"PeriodicalIF\":0.0000,\"publicationDate\":\"2023-05-07\",\"publicationTypes\":\"Journal Article\",\"fieldsOfStudy\":null,\"isOpenAccess\":false,\"openAccessPdf\":\"\",\"citationCount\":\"0\",\"resultStr\":null,\"platform\":\"Semanticscholar\",\"paperid\":null,\"PeriodicalName\":\"2023 IEEE 27th Workshop on Signal and Power Integrity (SPI)\",\"FirstCategoryId\":\"1085\",\"ListUrlMain\":\"https://doi.org/10.1109/SPI57109.2023.10145542\",\"RegionNum\":0,\"RegionCategory\":null,\"ArticlePicture\":[],\"TitleCN\":null,\"AbstractTextCN\":null,\"PMCID\":null,\"EPubDate\":\"\",\"PubModel\":\"\",\"JCR\":\"\",\"JCRName\":\"\",\"Score\":null,\"Total\":0}","platform":"Semanticscholar","paperid":null,"PeriodicalName":"2023 IEEE 27th Workshop on Signal and Power Integrity (SPI)","FirstCategoryId":"1085","ListUrlMain":"https://doi.org/10.1109/SPI57109.2023.10145542","RegionNum":0,"RegionCategory":null,"ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"","JCRName":"","Score":null,"Total":0}
引用次数: 0

摘要

计算具有级联DC - DC变换器的配电网的直流红外降提出了一些独特的挑战。降压稳压器DC - DC变换器具有非常动态的大信号切换行为,该行为依赖于负载,并且必须在计算DC IR降时将其平均为DC。当多个稳压器串联时,下游稳压器作为上游稳压器的负载。可以使用迭代方法来计算给定汇聚负载的最终稳压器级的状态,然后使用该稳压器的输入电流作为汇聚来计算上游稳压器的直流状态。这种采用简化直流稳压器模型的迭代方法可以比在瞬态域中求解快40美元。
本文章由计算机程序翻译,如有差异,请以英文原文为准。
DC IR Drop Steady State Estimate for Cascaded Switching Regulators
Calculating the DC IR drop for a power distribution network with cascaded dc-dc converters presents some unique challenges. The buck regulator dc-dc converters have a very dynamic large signal switching behavior that is load dependent and must be averaged to DC for the DC IR drop calculation. When cascading multiple regulators in series, the downstream regulator acts as the load for the upstream regulator. An iterative approach can be used to calculate the state of the final regulator stage for a given sink load, and then use this regulator's input current as the sink for the calculation of the DC state of the upstream regulator. This iterative approach with a simplified model for the DC regulator can be as much as $40\mathrm{x}$ faster than solving in the transient domain.
求助全文
通过发布文献求助,成功后即可免费获取论文全文。 去求助
来源期刊
自引率
0.00%
发文量
0
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
确定
请完成安全验证×
copy
已复制链接
快去分享给好友吧!
我知道了
右上角分享
点击右上角分享
0
联系我们:info@booksci.cn Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。 Copyright © 2023 布克学术 All rights reserved.
京ICP备2023020795号-1
ghs 京公网安备 11010802042870号
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术官方微信