Deteksi Level Ketinggian Air Dengan Nikelin, Encoder dan Sensor Tekanan Untuk Sistem Peringatan Dini Banjir

Floods and their problems show an increasing indication when rainfall is high. Data from BNPB shows that floods, landslides and tornadoes contributed to the total disasters in Indonesia in a decade. The existence of an early warning flood disaster can help evacuate before a disaster strikes. The system requires a water level detector as the basic data for determining flood predictions. In order to get the water level value, a touch water method can be used using electrodes or without touching the water with the help of pressure sensors, ultrasonic and imaging. Each method has advantages over the other. In this study, the effectivity and accuracy of detecting water levels were investigated using 3 methods: the direct touch of water through nickel wire, buoys with encoder, and pressure sensors. Detection of water levels can be used as a reference to obtain river water level data which is then connected via an IoT or internet connection as a reference for the Early Warning System for the arrival of floods. This study found that changes in water level of less than 30 cm can utilize buoys and encoders with an accuracy of detecting 5 to 6 counts per 1 mm increase in water level. Meanwhile, the measurement of less than 30 cm water level using nickel wire resulted in a non-linear value. The utilization of nickel wire can be used for a height of more than 30 cm where the change in resistivity has started to be linear. ADC change value is 2.93 mV/cm using 10 bit ADC at 5 Volt reference voltage. For water level heights of 50 cm and above, a pressure sensor can use a pressure sensor that can detect changes in pressure of 0.002 in Hg/mm or 0.05 mmHg/mm.