Treatment of oily wastewater by using polysulfide polymer

The discharge of water from oil fields is become one of the most significant environmental concerns associated with the oil sector. This study features a low-density polysulfide polymer prepared by Sulfur and used sunflower oils react directly. Because both sulfur and cooking oils are hydrophobic, the polymer can easily extract hydrocarbons like crude oil and diesel fuel from saltwater. Sulfur is a petroleum industry by-product, and leftover sunflower oil may be utilized as a raw material. 150 g food-grade used sunflower oil, 150 g sulfur, and 700 g finely powdered sodium chloride were used in an experiment to make polysulfide. The reaction temperature was adjusted at 180°C. The resulting polymer (a soft rubber) is friable; therefore, it was ground down using a mechanical grinder and screened for particles between 0.5 and 3 mm. The polymer was repeatedly rinsed with DI water to eliminate the sodium chloride porogen. The polymer was filtered through a sieve (0.5 mm) and pressed with a piece of flat plastic to remove surplus water after the final wash. The polymer was then dried in a sieve by putting it in a drying oven (UNB400, Germany) for 24 hours at 42 degrees Celsius. Kinetics of adsorption was examined with pseudo−first order, pseudo−second order and intra particle diffusion models. The experimental results show good fitting with pseudo−second order model for south oil adsorption on polysulfide polymer. Adsorption of north and south oils onto the prepared polysulfide polymer was done experimentally using batch apparatus with controlled conditions of temperature and stirring. Effects of temperature and initial oil concentration for the adsorption process were examined for the ranges (20−40) ◦C and (10−90) (g/l), respectively. The experimental data follows the Freundlich isotherm model with coefficient of variance (R2) equals, according to the study of adsorption equilibrium isotherms (0.99). According to the findings of the study, the greatest g/l of south oil removal equals 93 percent at the lowest temperature of 20 degrees Celsius.