Variable spreading factor-OFCDM with two dimensional spreading that prioritizes time domain spreading for forward link broadband wireless access

This paper proposes the optimum design for adaptively controlling the spreading factor in orthogonal frequency and code division multiplexing (OFCDM) with two-dimensional spreading according to the cell configuration, channel load, and propagation channel conditions, assuming the adaptive modulation and channel coding (AMC) scheme employing QPSK and 16QAM data modulation. Furthermore, we propose a two-dimensional channelization code assignment scheme to achieve skillfully orthogonal multiplexing of multiple physical channels. Computer simulation results elucidate that bit-interleaving in the frequency domain is superior to chip-interleaving especially for a full channel load because bit-interleaving exhibits a large randomization effect of burst errors, while still maintaining code orthogonality. In time domain spreading, the optimum spreading factor, except for an extremely high mobility case such as for the fading maximum Doppler frequency f/sub D/ = 1500 Hz, becomes SF/sub Time/ = 16, and it should be decreased to SF/sub Time/ = 8 for such a very fast fading environment using 16QAM modulation. When the channel load is light such as C/sub mux//SF = 0.25 (C/sub mux/ and SF denote the number of multiplexed codes and total spreading factor, respectively), the required average received signal energy per symbol-to-background noise power spectrum density ratio (E/sub s//N/sub 0/) is reduced as the spreading factor in the frequency domain is increased up to say SF/sub Freq/ = 32 for QPSK and 16QAM modulation, respectively (Note that, nevertheless, 16QAm modulation under such a lighter channel load condition is replaced by QPSK modulation together with two fold the channel load as 16QAM to achieve the same information bit rate). Meanwhile, when the channel load is close to full such as when C/sub mux//SF = 0.94, the optimum spreading factor in the frequency domain is SF/sub Freq/ = 1 for 16QAM modulation and SF/sub Freq/ = 1 to 8 for QPSK modulation according to the delay spread. Consequently, by setting several combinations of spreading factors in the time and frequency domains, the near maximum link capacity is achieved both in cellular and hot-spot cell configurations assuming various channel conditions.