Optimization of Surface Roughness and Tool Wear during Machining of AMMC using Taguchi Technique

IF 0.6 4区综合性期刊 Q3 MULTIDISCIPLINARY SCIENCES

Chiang Mai Journal of Science Pub Date : 2022-11-30 DOI:10.12982/cmjs.2022.095

Srinivasan Surendran, T. Sundaram, S. Kumar P.

引用次数: 0

Abstract

Metal matrix composite materials are used in several industrial applications due to its improved specifi c strength, capacity, good wear resistance, and high specifi c modulus and so on. In this work, the Aluminium alloy Al6061 is used as the matrix and 15% of volume fraction of silicon carbide is used as the reinforcing element to fabricate a MMC by stir casting process. The turning process parameters of Aluminium metal matrix composite (AMMC) considered in this work are cutting speed, feed, nozzle diameter and steam pressure and the responses surface roughness and tool wear. Taguchi technique is used in this research work to obtain optimum results and the S/N ratio is used as the quality characteristics and in this work L32 orthogonal array is used to conduct 32 experiments. It is observed that surface roughness of the AMMC is highly infl uenced by the nozzle diameter and it contributes to 19.87% and Tool wear of the AMMC is highly infl uenced by the steam pressure and it contributes to 7.12%.

查看原文本刊更多论文

田口法优化AMMC表面粗糙度和刀具磨损

金属基复合材料由于具有比强度高、容量大、耐磨性好、比模量高等特点，在工业上得到了广泛的应用。本文以Al6061铝合金为基体，以体积分数为15%的碳化硅为增强元素，采用搅拌铸造法制备了MMC。本文考虑的铝基复合材料车削工艺参数为切削速度、进给量、喷嘴直径和蒸汽压力以及表面粗糙度和刀具磨损的响应。本研究采用田口法获得最佳结果，以信噪比为质量特征，采用L32正交阵列进行32次实验。结果表明:喷嘴直径对AMMC表面粗糙度的影响较大，占19.87%;蒸汽压力对AMMC刀具磨损的影响较大，占7.12%。

本文章由计算机程序翻译，如有差异，请以英文原文为准。

求助全文

约1分钟内获得全文求助全文

来源期刊

Chiang Mai Journal of Science MULTIDISCIPLINARY SCIENCES-

CiteScore

1.00

自引率

25.00%

发文量

103

审稿时长

3 months

期刊介绍： The Chiang Mai Journal of Science is an international English language peer-reviewed journal which is published in open access electronic format 6 times a year in January, March, May, July, September and November by the Faculty of Science, Chiang Mai University. Manuscripts in most areas of science are welcomed except in areas such as agriculture, engineering and medical science which are outside the scope of the Journal. Currently, we focus on manuscripts in biology, chemistry, physics, materials science and environmental science. Papers in mathematics statistics and computer science are also included but should be of an applied nature rather than purely theoretical. Manuscripts describing experiments on humans or animals are required to provide proof that all experiments have been carried out according to the ethical regulations of the respective institutional and/or governmental authorities and this should be clearly stated in the manuscript itself. The Editor reserves the right to reject manuscripts that fail to do so.