The Screening of Permeation Enhancers for Trans-Nail Delivery of Terbinafine Hydrochloride

Abstract

In this project, several permeation enhancers were screened to improve the penetration of terbinafine hydrochloride into the nail plate. Human nail plate clippings were used to perform the screening studies. As the results of high throughput screening, tween 80, tween 60, tween 40 and tween 20 showed the ability to improve the penetration of terbinafine into the nail clippings ~2.5, 2, 3 and 2.5-fold more compared to control. The amount of terbinafine penetrated in the nail clippings in case of PEG-35 castor oil and PEG-40 castor oil was ~2.5 and 2.5-fold more compared to control. Glycerol, sodium lauryl sulfate and span 80 enhanced the penetration of terbinafine into the nail clippings by ~2, 4.5 and 2.5-fold more compared to control. Transcutol, TPGS, propylene glycol, isopropyl myristate, octyldodecanol, decyl oleate and oleyl oleate were not able to improve the penetration of terbinafine in the nail clippings compare to control. Screening studies concluded that sodium lauryl sulfate was found to be potential permeation enhancer which improved the penetration of terbinafine significantly. *Corresponding author: Abhishek Singh Kushwaha, TranSkin Research Pvt. Ltd, Bhopal, Madhya Pradesh, India, Tel: +91 9981983734; E-mail: askushwaha@transkinresearch.com Received June 26, 2018; Accepted July 18, 2018; Published July 28, 2018 Citation: Kushwaha AS (2018) The Screening of Permeation Enhancers for TransNail Delivery of Terbinafine Hydrochloride. J Bioequiv Availab 10: 75-77. 381. doi: 10.4172/0975-0851.1000381 Copyright: © 2018 Kushwaha AS. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited. Permeation enhancers The total amount of terbinafine (μg/mg) Control 0.10 ± 0.03 Tween 80 0.26 ± 0.09 Glycerol 0.20 ± 0.07 Transcutol 0.18 ± 0.02 PEG-35 castor oil 0.25± 0.04 PEG-40 castor oil 0.25 ± 0.05 Sodium lauryl sulfate 0.45 ± 0.06 Tween 40 0.30 ± 0.03 Tween 20 0.25 ± 0.05 TPGS 0.14 ± 0.02 Tween 60 0.23 ± 0.03 Propylene glycol 0.12 ± 0.02 Span 80 0.25 ± 0.05 Isopropyl mystirate 0.08 ± 0.05 Octyl dodecanol 0.08 ± 0.01 Decyl oleate 0.08 ± 0.02 Oleyl oleate 0.10 ± 0.03 Table 1: The total amount of terbinafine extracted from the nail clippings. Citation: Kushwaha AS (2018) The Screening of Permeation Enhancers for Trans-Nail Delivery of Terbinafine Hydrochloride. J Bioequiv Availab 10: 75-77. 381. doi: 10.4172/0975-0851.1000381 J Bioequiv Availab, an open access journal ISSN: 0975-0851 Volume 10(3): 75-77 (2018) 76 Kimwipes®. Nail clipping was placed dipped in a testing formulation once and placed in a 5 ml glass vial. Glass vial was kept at room temperature. After 24 h, each nail clipping was washed 5 times with a 3 ml of 50% ethanol solution in water. Each nail clipping was pat dried with Kimwipes®. The amount of terbinafine is penetrated in the nail plate after 24 h was quantified using HPLC method [1,2,8]. Extraction of terbinafine from nail clipping: Before starting a terbinafine extraction procedure, the weight of each nail clipping was recorded and then each clipping was placed in a 5 ml glass vial which was filled with a 3 ml of DMSO to extract the terbinafine. Nail clipping in DMSO was shook for around 24 h. 1 ml of extraction sample was collected and then filtered to using 0.45 μm syringe filter. Extraction was analyzed using HPLC method [1,2,8]. Analytical method: The amount of terbinafine was quantified using Shimadzu Prominence-i 2030C plus HPLC (high-performance liquid chromatography) which was consisted of quaternary pump, auto sampler and UV-VIS Detector. The mobile phase was prepared by mixing aqueous phase and acetonitrile in a 60:40 proportion. The pH of the mobile was adjusted at pH 2 using 0.096M triethyl amine, 0.183M orthophosphoric acid. Terbinafine was eluted at a flow rate of 1.0 ml/min at 224 nm. The HPLC method was validated from 1 μg/ml of terbinafine to 10 μg/ml [9,10]. Statistical analysis: Statistical analysis of the data of high throughput screening studies was performed using ANOVA test. The p value less than 0.05 was considered statistical significant. Result and Discussion Nail plate consists of three layers which are dorsal, intermediate and ventral layer. Dorsal layer is the outer most layer which is considered to be the main barrier for the drug delivery [3]. Ventral layer is directly attached to the nail bed and it is more hydrated than dorsal layer. Topical nail delivery of drugs is mostly preferred for the treatment of nail diseases due to the direct application of drug on the site of infection. In recent years, many active (Iontophoresis, electroporation, and ultrasound) and passive (chemical penetration enhancers) techniques have been explored to improve the trans-ungual permeation the terbinafine [3,6,11]. Murthy et al., screened several permeation enhancers to improve the permeation of terbinafine across the nail [8]. Nair et al., also investigated the iontophoresis technique to improve the permeation of terbinafine [5]. Kushwaha et al. reported to deliver terbinafine hydrochloride from hyponychium region to the nail apparatus. In this project, we investigated some new permeations enhancers to enhance the penetration of terbinafine into the nail plate [12,13]. In topical formulations, permeation enhancers are chosen at the first-place due lower cost of treatment and patient compliance. Permeation enhancer are chemicals which improve the permeation of drugs into and across the nail plate using several mechanisms. Kushwaha et al. reported that some permeation enhancers break the disulfide bond of the keratin proteins and some improve the water holding capacity of nail plate to enhance the permeation of drugs into and across the nail plate [1,13]. In this project, vitamin ETPGS is used as a non-ionic surfactant. It is well known for its emulsifying and solubilizing the poor water-soluble drugs [14,15]. KolliphorTM RH 40 (PEG-40 castor oil) and Kolliphor® EL (PEG -35 castor oil) are commonly used as non-ionic solubilizer and emulsifier [15,16]. Tweens (Tween 20, 40, 60 and 80) and spans are non-ionic surfactant and used to as solubilizer and emulsifier [15]. Oleyl oleate, decyl oleate and octyldodecanol are used as the skin-Conditioning agent and permeation enhancers for skin delivery of drugs [17]. Isopropyl myristate is used as solvent and permeation enhancer for skin delivery of drugs [18]. Glycerol and propylene glycol are commonly used as moisturizing agent and solvents [15]. Transcutol is a very effective permeation enhancer and solvent for skin delivery of drugs. Sodium lauryl sulfate is a ionic surfactant, normally used in the shampoos and gels [2,15]. As a result of screening study, tween 80, tween 60, tween 40 and tween 20 improved the penetration of terbinafine ~2.5, 2, 3 and 2.5-fold more compared to control. The amount of terbinafine extracted from nail clippings in case of PEG-35 castor oil and PEG-40 castor oil was ~2.5 and 2.5-fold more compared to control. Glycerol, sodium lauryl sulfate and span 80 enhanced the penetration of terbinafine into the nail clippings by ~2, 4.5 and 2.5-fold more compared to control. Transcutol, TPGS, propylene glycol, isopropyl myristate, octyldodecanol, decyl oleate and oleyl oleate were not found to be effective to improve the penetration of terbinafine compare to control.