{"title":"Effect of Feed Flowrates on the Physical Properties and Antioxidant of Mahkota Dewa (Phaleria Macrocarpa) Encapsulated Powder","authors":"S. K. Abdul Mudalip, M. N. Kathiman, J. Gimbun","doi":"10.31436/iiumej.v23i2.1713","DOIUrl":null,"url":null,"abstract":"This paper presents an experimental study on the encapsulation of Mahkota Dewa extracts by maltodextrin using spray drying. The bioactive compound from dried Mahkota Dewa was obtained using a subcritical water extraction process prior to a spray drying process. The effect of feed flow rate (485 to 2115 ml/h) was investigated using one-factor-at-a-time (OFAT). It was observed that the mean particle size increase varied from 3.55 to 8.38 µm when the feed flow rate increased from 485 to 2115 ml/h. Moisture content increased 4.88 to 6.83% as the feed flow rate increased from 485 to 2115 ml/h, whereas the antioxidant activity increased slightly from 90.48 to 91.65%. The findings from this study showed that decrease in feed flow rate reduces antioxidant activity, moisture content, and particle size.\nABSTRAK: Kertas kerja ini adalah berkenaan kajian eksperimen melalui proses pengkapsulan ekstrak buah Mahkota Dewa dengan menggunakan maltodekstrin melalui teknik pengeringan semburan. Sebatian bioaktif dari buah Mahkota Dewa kering diperoleh melalui teknik pengekstrakan air subkritikal sebelum proses pengeringan semburan. Kesan kadar aliran masuk (485 hingga 2115 ml/jam) dikaji menggunakan konsep satu-faktor-pada-satu-masa (OFAT). Dapatan kajian mendapati bahawa purata saiz zarah meningkat dari 3.55 kepada 8.38 µm ketika kadar aliran masuk meningkat dari 485 sehingga 2115 ml/jam. Kandungan kelembapan meningkat dari 4.88 kepada 6.83% dengan kenaikan kadar aliran masuk dari 485 hingga 2115 ml/jam, sedangkan aktiviti antioksida meningkat sedikit dari 90.48 hingga 91.65%. Dapatan kajian menunjukkan bahawa penurunan kadar aliran masuk berkurang melalui aktiviti antioksida, kandungan kelembapan dan saiz zarah.","PeriodicalId":13439,"journal":{"name":"IIUM Engineering Journal","volume":"8 1","pages":""},"PeriodicalIF":0.6000,"publicationDate":"2022-07-04","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"1","resultStr":null,"platform":"Semanticscholar","paperid":null,"PeriodicalName":"IIUM Engineering Journal","FirstCategoryId":"1085","ListUrlMain":"https://doi.org/10.31436/iiumej.v23i2.1713","RegionNum":0,"RegionCategory":null,"ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q3","JCRName":"ENGINEERING, MULTIDISCIPLINARY","Score":null,"Total":0}
引用次数: 1
Abstract
This paper presents an experimental study on the encapsulation of Mahkota Dewa extracts by maltodextrin using spray drying. The bioactive compound from dried Mahkota Dewa was obtained using a subcritical water extraction process prior to a spray drying process. The effect of feed flow rate (485 to 2115 ml/h) was investigated using one-factor-at-a-time (OFAT). It was observed that the mean particle size increase varied from 3.55 to 8.38 µm when the feed flow rate increased from 485 to 2115 ml/h. Moisture content increased 4.88 to 6.83% as the feed flow rate increased from 485 to 2115 ml/h, whereas the antioxidant activity increased slightly from 90.48 to 91.65%. The findings from this study showed that decrease in feed flow rate reduces antioxidant activity, moisture content, and particle size.
ABSTRAK: Kertas kerja ini adalah berkenaan kajian eksperimen melalui proses pengkapsulan ekstrak buah Mahkota Dewa dengan menggunakan maltodekstrin melalui teknik pengeringan semburan. Sebatian bioaktif dari buah Mahkota Dewa kering diperoleh melalui teknik pengekstrakan air subkritikal sebelum proses pengeringan semburan. Kesan kadar aliran masuk (485 hingga 2115 ml/jam) dikaji menggunakan konsep satu-faktor-pada-satu-masa (OFAT). Dapatan kajian mendapati bahawa purata saiz zarah meningkat dari 3.55 kepada 8.38 µm ketika kadar aliran masuk meningkat dari 485 sehingga 2115 ml/jam. Kandungan kelembapan meningkat dari 4.88 kepada 6.83% dengan kenaikan kadar aliran masuk dari 485 hingga 2115 ml/jam, sedangkan aktiviti antioksida meningkat sedikit dari 90.48 hingga 91.65%. Dapatan kajian menunjukkan bahawa penurunan kadar aliran masuk berkurang melalui aktiviti antioksida, kandungan kelembapan dan saiz zarah.
本文对麦芽糖糊精喷雾干燥包封马可达杜瓦提取物进行了实验研究。在喷雾干燥过程之前,使用亚临界水提取工艺从干燥的马科塔杜瓦中获得生物活性化合物。采用单因素单次法(OFAT)研究了进料流量(485 ~ 2115 ml/h)的影响。当进料流量从485 ~ 2115 ml/h增加时,平均粒径增加幅度为3.55 ~ 8.38µm。随着进料流量从485 ~ 2115 ml/h增加,水分含量增加4.88 ~ 6.83%,抗氧化活性从90.48 ~ 91.65%略有增加。本研究结果表明,进料流量的减少会降低抗氧化活性、水分含量和颗粒大小。摘要/ abstract摘要:Kertas kerja ini adalah berkenaan kajian ekspermelalui, pengk荚膜,ekstrak buah Mahkota Dewa dengan menggunakan maltodekstrin melalui, teknak pengeringan和semburan。sebastian bioaktif dari buah Mahkota Dewa kering diperoleh melalui teknik pengekstrakan空气亚临界sebelum处理pengeringan和semburan。Kesan kadar aliran masuk (485 hinga 2115 ml/jam) dikaji menggunakan konsep satu-faktor-pada-satu-masa (OFAT)Dapatan kajian mendapati bahawa purata saiz zarah meningkat dari 3.55 kepaada 8.38µm ketika kadar aliran masuk meningkat dari 485 seingga 2115 ml/jamKandungan kelembapan meningkat dari 4.88 kepada 6.83% dengan kenaikan kadar aliran masuk dari 485 hingga 2115 ml/jam, sedangkan aktiviti antioksida meningkat sedikit dari 90.48 hingga 91.65%。我的朋友,我的朋友,我的朋友,我的朋友,我的朋友,我的朋友,我的朋友,我的朋友。
期刊介绍:
The IIUM Engineering Journal, published biannually (June and December), is a peer-reviewed open-access journal of the Faculty of Engineering, International Islamic University Malaysia (IIUM). The IIUM Engineering Journal publishes original research findings as regular papers, review papers (by invitation). The Journal provides a platform for Engineers, Researchers, Academicians, and Practitioners who are highly motivated in contributing to the Engineering disciplines, and Applied Sciences. It also welcomes contributions that address solutions to the specific challenges of the developing world, and address science and technology issues from an Islamic and multidisciplinary perspective. Subject areas suitable for publication are as follows: -Chemical and Biotechnology Engineering -Civil and Environmental Engineering -Computer Science and Information Technology -Electrical, Computer, and Communications Engineering -Engineering Mathematics and Applied Science -Materials and Manufacturing Engineering -Mechanical and Aerospace Engineering -Mechatronics and Automation Engineering