Physicochemical Stability of Cefotaxime Sodium in Polypropylene Syringes at High Concentrations for Intensive Care Units

E. D’huart, J. Vigneron, F. Blaise, A. Charmillon, B. Demoré
{"title":"Physicochemical Stability of Cefotaxime Sodium in Polypropylene Syringes at High Concentrations for Intensive Care Units","authors":"E. D’huart, J. Vigneron, F. Blaise, A. Charmillon, B. Demoré","doi":"10.1515/PTHP-2019-0006","DOIUrl":null,"url":null,"abstract":"Abstract Background Cefotaxime sodium is an antibiotic used to treat severe infections such as in intensive care units (ICUs). The recommended dose of cefotaxime sodium can vary from 3 grams (g) to 24 g per day and publications have demonstrated that continuous administration of cefotaxime sodium is the preferred mode of administration. In ICUs, a minimum volume is used for patients requiring fluid restriction, leading to high concentrations of cefotaxime sodium. The objective was to study the stability of cefotaxime sodium solutions at 83.3 mg/mL and 125 mg/mL, diluted in 0.9 % sodium chloride (0.9 % NaCl) or in 5 % glucose (G5 %), stored in polypropylene syringes, after the preparation and after a 6-hour and a 12-hour storage at 20–25 °C. Methods Three syringes for each condition were prepared. At each time of the analysis, three samples for each syringe were prepared and analysed by high performance liquid chromatography (HPLC) coupled to a photodiode array detector. The method was validated according to the International Conference on Harmonisation Q2(R1). Physical stability was evaluated by visual and subvisual inspection (turbidimetry by UV spectrophotometry at 350, 410 and 550 nm as recommended by the European Consensus Conference). pH and osmolality values were measured at each time of the analysis. Results For each solvent, cefotaxime sodium solutions at 83.3 mg/mL and 125 mg/mL retained more than 90 % of the initial concentration after 12 hours. During the stability study, pH values decreased slightly, the intensity of the yellow colour increased and values of absorbance increased progressively for each wavelength and each condition. An additional peak with a relative retention of 3.01 was also observed after the forced degradation gradually increased up to 4.01 % and 3.17 % of the total of surface area of the peaks present on the chromatogram after 12 hours in 0.9 % NaCl and in G5 % respectively. Conclusions In view of the results and despite the fact that solutions retained more than 90 % of the initial concentration after HPLC analysis, we propose to limit the stability of cefotaxime sodium in 0.9 % NaCl and G5 % at 83.3 and 125 mg/mL at 6 hours. These stability data of highly concentrated solutions provide an additional knowledge to assist ICUs in daily practice. This work also demonstrates that highly concentrated cefotaxime sodium solutions are physically unstable after a 6-hour storage and cannot be administered as a daily infusion.","PeriodicalId":19802,"journal":{"name":"Pharmaceutical Technology in Hospital Pharmacy","volume":"52 1","pages":"59 - 67"},"PeriodicalIF":0.0000,"publicationDate":"2019-05-17","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"8","resultStr":null,"platform":"Semanticscholar","paperid":null,"PeriodicalName":"Pharmaceutical Technology in Hospital Pharmacy","FirstCategoryId":"1085","ListUrlMain":"https://doi.org/10.1515/PTHP-2019-0006","RegionNum":0,"RegionCategory":null,"ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"","JCRName":"","Score":null,"Total":0}
引用次数: 8

Abstract

Abstract Background Cefotaxime sodium is an antibiotic used to treat severe infections such as in intensive care units (ICUs). The recommended dose of cefotaxime sodium can vary from 3 grams (g) to 24 g per day and publications have demonstrated that continuous administration of cefotaxime sodium is the preferred mode of administration. In ICUs, a minimum volume is used for patients requiring fluid restriction, leading to high concentrations of cefotaxime sodium. The objective was to study the stability of cefotaxime sodium solutions at 83.3 mg/mL and 125 mg/mL, diluted in 0.9 % sodium chloride (0.9 % NaCl) or in 5 % glucose (G5 %), stored in polypropylene syringes, after the preparation and after a 6-hour and a 12-hour storage at 20–25 °C. Methods Three syringes for each condition were prepared. At each time of the analysis, three samples for each syringe were prepared and analysed by high performance liquid chromatography (HPLC) coupled to a photodiode array detector. The method was validated according to the International Conference on Harmonisation Q2(R1). Physical stability was evaluated by visual and subvisual inspection (turbidimetry by UV spectrophotometry at 350, 410 and 550 nm as recommended by the European Consensus Conference). pH and osmolality values were measured at each time of the analysis. Results For each solvent, cefotaxime sodium solutions at 83.3 mg/mL and 125 mg/mL retained more than 90 % of the initial concentration after 12 hours. During the stability study, pH values decreased slightly, the intensity of the yellow colour increased and values of absorbance increased progressively for each wavelength and each condition. An additional peak with a relative retention of 3.01 was also observed after the forced degradation gradually increased up to 4.01 % and 3.17 % of the total of surface area of the peaks present on the chromatogram after 12 hours in 0.9 % NaCl and in G5 % respectively. Conclusions In view of the results and despite the fact that solutions retained more than 90 % of the initial concentration after HPLC analysis, we propose to limit the stability of cefotaxime sodium in 0.9 % NaCl and G5 % at 83.3 and 125 mg/mL at 6 hours. These stability data of highly concentrated solutions provide an additional knowledge to assist ICUs in daily practice. This work also demonstrates that highly concentrated cefotaxime sodium solutions are physically unstable after a 6-hour storage and cannot be administered as a daily infusion.
重症监护病房高浓度聚丙烯注射器中头孢噻肟钠的物理化学稳定性
背景头孢噻肟钠是一种用于重症监护病房(icu)等重症感染治疗的抗生素。头孢噻肟钠的推荐剂量可以从每天3克(g)到24克不等,出版物表明,连续给药头孢噻肟钠是首选的给药方式。在icu中,对于需要限制液体的患者,使用最小容量,导致头孢噻肟钠浓度较高。目的是研究83.3 mg/mL和125 mg/mL头孢噻肟钠溶液,在0.9%氯化钠(0.9% NaCl)或5%葡萄糖(g5%)中稀释,在聚丙烯注射器中储存,制备后,在20-25℃下储存6小时和12小时的稳定性。方法各配制3支注射器。在每次分析时,每个注射器制备3个样品,并通过高效液相色谱(HPLC)耦合到光电二极管阵列检测器进行分析。该方法根据国际协调会议Q2(R1)进行了验证。通过目视和亚目视检查评估物理稳定性(欧洲共识会议推荐的350、410和550 nm的紫外分光光度浊度法)。在每次分析时测量pH和渗透压值。结果83.3 mg/mL和125 mg/mL的头孢噻肟钠溶液在12 h后仍保持初始浓度的90%以上。在稳定性研究过程中,在每个波长和每个条件下,pH值略有下降,黄色强度增加,吸光度值逐渐增加。在0.9% NaCl和g5% NaCl溶液中,强制降解作用12 h后,分别增加到色谱峰表面积的4.01%和3.17%,形成了一个相对保留率为3.01的附加峰。结论尽管经HPLC分析,头孢噻肟钠溶液保留了90%以上的初始浓度,但我们建议限制头孢噻肟钠在0.9% NaCl和g5%浓度下的稳定性,分别为83.3和125 mg/mL,维持6 h。这些高浓度溶液的稳定性数据为icu的日常实践提供了额外的知识。这项工作还表明,高浓度头孢噻肟钠溶液在储存6小时后物理不稳定,不能作为每日输注给药。
本文章由计算机程序翻译,如有差异,请以英文原文为准。
求助全文
约1分钟内获得全文 求助全文
来源期刊
自引率
0.00%
发文量
7
审稿时长
12 weeks
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
确定
请完成安全验证×
copy
已复制链接
快去分享给好友吧!
我知道了
右上角分享
点击右上角分享
0
联系我们:info@booksci.cn Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。 Copyright © 2023 布克学术 All rights reserved.
京ICP备2023020795号-1
ghs 京公网安备 11010802042870号
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术官方微信