Reference Measurement of Roundwood by Fringe Projection

Abstract

The metrological verification of log scanners requires logs with accurately known dimensions as test objects. The measurement of the lengths and diameters must be traceable back to the SI (International System of Units) unit of length. The results have to be reported with the corresponding measurement uncertainties. The uncertainties are required to be 5 to 10 times lower than the corresponding maximum permissible errors allowed for the log scanner under test. This article presents a procedure for the reference measurement of logs using an off-the-shelf fringe projection system along with uncertainty budgets for the measured dimensions. The length and diameters are determined from the highly resolved mesh obtained by fringe projection using techniques from computational geometry and coordinate metrology. Corrections are applied to the length and diameter values to remove the systematic effect caused by scattering of projected light below the partially transparent log surface. The influence of the fringe projection system on the measured dimensions is determined by measurements of calibrated artifacts, which also provide the traceability back to the SI unit of length. The measurement is illustrated by the example of a log with a length of 2 m and a diameter of 280 mm. The corresponding uncertainty budgets, confirmed by repeat measurements, result in expanded uncertainties (confidence interval 95%) of 6 mm and 0.13 mm for length and diameter, respectively. These low values qualify the fringe projection measurement along with accompanying evaluation procedure to provide logs as reference objects for the verification of log scanners.