Exact shell solutions for conical springs. III. Belleville springs with variable thickness

Abstract

PurposeIn the current manuscript, the authors examine the Belleville spring with the variable thickness. The thickness is assumed to be variable along the meridional and parallel coordinates of conical coordinate system. The calculation of the Belleville springs includes the cases of the free gliding edges and the edges on cylindric curbs, which constrain the radial movement. The equations developed here are based on common assumptions and are simple enough to be applied to the industrial calculations.Design/methodology/approachIn the current manuscript, the authors examine the Belleville spring with the variable thickness. The calculation of the Belleville springs investigates the free gliding edges and the edges on cylindric curbs with the constrained radial movement. The equations developed here are based on common assumptions and are simple enough to be applied to the industrial calculations.FindingsThe developed equations demonstrate that the shift of the inversion point to the inside edge does not influence the bending of the cone. On the contrary, the character of the extensional deformation (circumferential strain) of the middle surface alternates significantly. The extension of the middle surface of free gliding spring occurs outside the inversion. The middle surface of the free gliding spring squeezes inside the inversion point. Contrarily, the complete middle surface of the disk spring on the cylindric curb extends. This behavior influences considerably the function of the spring.Research limitations/implicationsA slotted disk spring consists of two segments: a disk segment and a number of lever arm segments. Currently, the calculation of slotted disk spring is based on the SAE formula (SAE, 1996). This formula is limited to a straight slotted disk spring with freely gliding inner and outer edges.Practical implicationsThe equations developed here are based on common assumptions and are simple enough to be applied to the industrial calculations. The developed method is applicable for disk springs with radially constrained edges. The vertical displacements of a disk spring result from an axial load uniformly distributed on inner and outer edges. The method could be directly applied for calculation of slotted disk springs.Originality/valueThe nonlinear governing equations for the of Belleville spring centres were derived. The equations describe the deformation and stresses of thin and moderately thick washers. The variation method is applicable for the disc springs with free gliding and rigidly constrained edges. The developed method is applicable for Belleville spring with radially constrained edges. The vertical displacements of a disc spring result from an axial load uniformly distributed on inner and outer edges.