[Design and Experimental Study of Electrical Impedance Tomography System for Tumor Ablation Boundary Monitoring].

Abstract

The minimally invasive thermal ablation technology differs from traditional surgical operations, which requires auxiliary equipment to evaluate ablation results. However, the ultrasound and CT currently used in clinical practice have shortcomings such as artifacts and radiation. Therefore, this paper proposes a design for a minimally invasive thermal ablation evaluation system based on the principle of electrical impedance tomography technology to monitor the ablation range. At the same time, the innovative introduction of a programmable gain feedforward signal as the parameter signal of the multiplier demodulator in the electrical impedance tomography system design can effectively solve the problem of weak signals being submerged in noise and improve imaging accuracy. The system controls the amplitude of the excitation current signal and the acquisition / processing of boundary voltages via an STM32, uploads the collected data to an upper computer, and reconstructs the conductivity distribution using the Newton-Raphson algorithm to map the size of the ablation area. Experimental results show that the system can effectively reflect the size of the microwave ablation area. Under the same minimally invasive ablation parameters, the average imaging errors are 0.6 mm for the long diameter, 0.8 mm for the short diameter, and 1.75% for the axial ratio (long diameter / short diameter), demonstrating high consistency. This verifies the technical potential of electrical impedance tomography in minimally invasive thermal ablation.