Characterization of the high-pressure suspension jet for efficient cutting and abrasive circularity

IF 3.2 3区工程技术 Q2 ENGINEERING, INDUSTRIAL

Cirp Annals-Manufacturing Technology Pub Date : 2025-01-01 DOI:10.1016/j.cirp.2025.04.067

Florian Morczinek , Martin Dix (3) , Rafael Wertheim (1)

引用次数: 0

Abstract

To optimize the workpiece removal process and maximize the fraction of reusable abrasive particles, it is necessary to ascertain the characteristics of the high-pressure suspension jet process, including the kinetic energy of the particles in the jet. In this study, the particle velocity and the change in their size were measured and analyzed. It was found that due to breakage the average particle size decreases by up to 35 % during the acceleration process in the nozzle. The results showed that the particle size has insignificant influence on particle velocity, while the kinetic energy of an average particle decreased by up to 72 %.

查看原文本刊更多论文

高压悬浮射流高效切割和磨料圆度的表征

为了优化工件去除工艺，最大限度地提高可重复使用磨料颗粒的比例，需要确定高压悬浮射流过程的特性，包括射流中颗粒的动能。在本研究中，测量和分析了颗粒的速度及其大小的变化。研究发现，在喷嘴加速过程中，由于破碎，平均粒径降低了35%。结果表明，粒径对颗粒速度的影响不显著，而平均颗粒的动能降低了72%。

本文章由计算机程序翻译，如有差异，请以英文原文为准。

求助全文

约1分钟内获得全文求助全文

来源期刊

Cirp Annals-Manufacturing Technology 工程技术-工程：工业

CiteScore

7.50

自引率

9.80%

发文量

137

审稿时长

13.5 months

期刊介绍： CIRP, The International Academy for Production Engineering, was founded in 1951 to promote, by scientific research, the development of all aspects of manufacturing technology covering the optimization, control and management of processes, machines and systems. This biannual ISI cited journal contains approximately 140 refereed technical and keynote papers. Subject areas covered include: Assembly, Cutting, Design, Electro-Physical and Chemical Processes, Forming, Abrasive processes, Surfaces, Machines, Production Systems and Organizations, Precision Engineering and Metrology, Life-Cycle Engineering, Microsystems Technology (MST), Nanotechnology.