Impact of lead on an axisymmetric, single bead blown powder DED overhung geometry

Abstract

Metal additive manufacturing can be utilized for the near net-shape manufacture of components in a layer wise technique. Traditionally, the buildup process is conducted in the direction of gravity or bottom to top in the vertical orientation; however, with the availability of commercial systems with additive heads or fixturing that can index from vertical, and the need to manufacture larger parts without modifying available systems, the limitation of manufacturing from bottom to top is removed enabling the buildup of larger components printed at an angle from vertical. The effect of gravity on the melt pool and as-deposited component quality when printing off vertical is unknown in literature, especially for axisymmetric components. This understanding is critical for the advancement of manufacturing components of increased size in 4 and 5-axis additive systems. This investigation utilizes blown powder directed energy deposition to evaluate the change in as-printed geometry when the start point is altered in relation to gravity while the part rotates to manufacture an axisymmetric component. The objectives of this work are to determine the impact of the deposition location on the geometric variability on axisymmetric components. This investigation tests the hypothesis that differences in layer height exist due to a change in catchment efficiency when the deposition location is moved to a tangent of the round geometry due to a change in the melt pool dynamics. It was found the ideal deposition location when printing at 26.6-degrees from vertical was at −90-degrees from the top center point of the component, along the tangent, where gravity was pushing the melt pool down, but the rotation of the part was pulling the deposited material towards the top center of the component. This work provides an understanding of layer height stability and catchment efficiency to guide print orientation strategy for high-aspect ratio components. It was found the −90-degree lead deposition had the best layer height stability at 0.6 % as compared to the top-center at 6.3 % and +90-degree deposition location at 9.2 % for the nominal programmed layer height. The change in layer height also effected the final diameter the greatest for the top center deposition location where the diameter diverged by 2.5 % during the overbuild condition and converged by 0.6 %. This finding will increase the manufacturing efficiency of axisymmetric components by increasing the passive stability of the printing process for the successful manufacture of parts without the need for perfectly calibrated manufacturing parameters.