Low-Cycle Fracture Resistance of the Superalloy at Single- and Two-Frequency Modes of Loading

Abstract

Fatigue and long static damage to the majority of high-loaded units develop under repeated stresses and strains of large amplitudes in elastic and elastoplastic regions at a low number of the main cycles and superimposition of dynamic stresses of significantly smaller value with higher frequencies, which results in the so-called two-frequency modes of loading. It is shown that, in the region of elevated and high temperatures, which determine the manifestation of temperature and time effects in the material, the rate and duration of deformation which enter the basic equation for determination of the fatigue life through the frequency and time of loading become the most significant parameters determining the fracture process. The results of theoretical and experimental study carried out on nickel superalloy specimens under a rigid mode of loading and high temperatures have shown that estimation of the strength and fatigue life in this case for the single-frequency and two-frequency modes of loading can be performed on the basis of the analysis of strain parameters and diagrams of cyclic elastoplastic deformation using the deformation-kinetic criterion of summation of damage accumulated in the material. A decrease in the fatigue life under two-frequency mode of loading and the possibility of estimating it using the specified criterion and corresponding dependences with the introduction of the parameters of frequency/amplitude ratios of the strains (both full and that imposed on the main process) are experimentally proved. The calculated dependences include the parameters of temperature conditions and frequency and duration of loading, which allows (when assessing damage from low-frequency and high-frequency components of cyclic strains) taking into account the effects of cyclicity and time of loading, as well as the existence of a variable coefficient of the asymmetry of high-frequency cycles of the two-frequency mode during high-temperature cyclic elastoplastic deformation.