Experimental and Numerical Indentation Tests to Study the Crack Growth Properties Caused by Various Indenters Under High Temperature

Abstract

This paper investigates the influence of indenter shape and rock texture on the crack growth properties and rock hardness. For this purpose, two different rock specimens such as basalt and marble with various textures were prepared and tested by Vickers indentation hardness device with rhombus indenter shape under two different temperatures of 35°C and 100°C. Concurrent with the experimental test, Vickers indentation simulations have been done on three calibrated rock models with nine different indenter shapes. The tensile strength of marble was 8 MPa, while basalt had a tensile strength of 10.8 MPa. Regarding compressive strength, marble exhibited 71 MPa, whereas basalt had a compressive strength of 153 MPa. Marble and basalt had elastic moduli of 45 and 95 GPa, respectively. The physical loading was applied vertically at a rate of 0.004 mm/min. The rock's texture and temperature significantly impact Vickers indentation hardness. Penetration by the Vickers indenter creates an elastic‐plastic stress field, leading to radial cracks due to exceeding the critical stress level. Ring cracks are caused by bulging of the test material and nested cracks directly under the indentation due to high shear and bending stresses in the region. The indentation shape affected the extent of the damage zone below it, leading to increased crack growth with smaller indentation diameters. The radial fracture number increased when the cross‐section changed from circular to quadrilateral shape. The crack growth and damage zone area increased with higher rock temperature due to increased rock brittleness.