Influence of the material properties on the clinching process and the resulting load-bearing capacity of the joint

Abstract

This study focuses on the phenomenological change in material strength caused by a specific heat treatment and the subsequent analysis of the influence on the clinching process and the resulting joint properties. For this purpose, three series of tests were performed. In the first series of tests, the influence of heat treatment up to 340 °C on the mechanical properties of an age-hardenable AlMgSi alloy was investigated. Holding time and temperature were varied and the material strength was evaluated by tensile and hardness tests. Two strength-increasing and two strength-reducing heat treatment parameters were identified. In the second series of tests, selected heat treatment parameters were applied to a larger number of specimens and the joint strength was investigated by shear and head tensile tests. In the shear tensile test, mainly the properties of the punch-side material have an influence on the resulting joint strength. A change in strength of the die-side material can be neglected. In contrast, the properties of both sheets are important in the head tensile test. The strength of the joint will only increase if the strength of both sheets is increased. In general, a strength increasing heat treatment resulted in higher joint strength. In the third series of tests, the factor of punch displacement was considered, which was demonstrated to directly influence the formation of the clinched joint geometry.