Surface conductivity of clays

Abstract

Clay minerals are extensively used in a wide range of applications. In particular, clay-bearing formations are considered as suitable radioactive waste repository. Electrical resistivity tomography is an appropriate tool to monitor the properties of clay-bearing locations. However, an inherent drawback of a conventional resistivity survey is its ambiguity in distinguishing between the effects of groundwater salinity, clay content, and porosity. A discrimination can be achieved on the basis of the induced polarization method that provides a complex conductivity. The main purpose of this study is the investigation of the complex conductivity of clay samples with a special focus on the contribution of surface conductivity produced by an excess of ions in the electrical double layer coating the solid particles. Six clay mixtures were selected that include an almost pure kaolinite sample, a sample consisting of a mixture of kaolinite, illite, and smectite, a crushed saponite breccia, a Ca-bentonite sample, and two illite clay samples. Besides the enriched kaolinite, the other samples are natural geomaterials that contain more than 40 weight per cent clay minerals. The mineralogical compositions of the samples were determined by quantitative X-ray diffraction analysis. The clay powder was mixed with a varying volume of sodium chloride solution to get plastic state clay samples with varying water content. The samples were investigated by the spectral induced polarization method in a frequency range between 1 mHz and 1 kHz. The resulting complex conductivity spectra indicate a decrease of the real part of the electrical conductivity with rising water content for the illite, bentonite and saponite breccia samples. The overall conductivity of these clay samples is dominated by their surface conductivity. In contrast, the electrical conductivity of kaolinite and kaolinite-illite mixture does not show any significant changes with the water content. For all samples, the imaginary part of electrical conductivity increases at low water content. The real part of the surface conductivity indicates a linear dependence on the volumetric clay content. The slope of this linear relationship can be used to distinguish the types of clay. The ratio between imaginary conductivity and surface conductivity, which decreases with increasing clay content, proves to be a suitable parameter that characterizes the connectivity of clay aggregates in the sample. The surface conductivity of the pure kaolinite sample has been determined in an additional multi-salinity experiment. The resulting surface conductivity is in good agreement with the experiment of varying water content. The multi-salinity experiment has shown that the resulting petrophysical parameters depend on the procedure of sample packing, which may lead to anisotropy. The effect of anisotropy is attributed to the alignment of the plate-like kaolinite particles in the course of the packing and consolidation procedure.