Flow and Heat Transfer Experimental Study for 3D-Printed Solar Receiving Tubes with Helical Fins at Internal Surface

Abstract

3D-printing technology was applied to fabricate novel solar thermal collection tubes that have internal heat transfer enhancement fins and external surfaces with high solar absorptivity and low emissivity due to the use of different materials in one tube. Helical fins were selected to introduce circumferential flow and thus minimize the circumferential temperature difference of the tube that receives sunlight on one side. The structures of the helical fins were previously optimized from CFD analysis with the objective of low entropy production rate by looking for high heat transfer coefficient and relatively lower pressure loss. High temperature alloy, Inconel-718, was used to 3D print the tubes, which can resist corrosion for the potential application of molten chloride salts as heat transfer fluid. Experimental tests were carried out using water as the heat transfer fluid with the high heat flux provided by a tubular furnace heater. The tested Reynolds number ranges from 3.9 × 103 to 6.1 × 104. Heat transfer coefficients of up to 2.8 times of that of smooth tube could be obtained with the expenses of increased pressure loss compared to that of smooth tube. The total system entropy generation can be significantly reduced due to the benefit of heat transfer enhancement that is greater than the expenses of the increased pressure loss. The experimental results of the 3D-printed heat transfer tubes confirmed the CFD-based results of fin optimization. The novel heat transfer tube is recommended for application in concentrating solar power systems.