Experimental Investigation on the 3D Printing of Nylon Reinforced by Carbon Fiber through Fused Filament Fabrication Process, Effects of Extruder Temperature, and Printing Speed

Abstract

This study investigated how the extruder temperature, printing speed, and specimen geometry interact during a tensile test of continuous carbon fiber-reinforced nylon matrix composites produced by the fused deposition modelling (FDM) process. The investigation utilized statistical techniques. For this purpose, tensile examinations were done on manufactured samples using a testing apparatus. The study’s objective is to identify the most efficient specimen geometry for tensile testing result optimization and to maximize the 3D printing process’s capability for producing complex, freeform patterns in these composites. In this study, the input parameters required for the response surface methodology (RSM) were varying extruder temperature (240-255°C) and printing speed (60-80 mm/s), and experimental responses included modulus, elongation at break, and weight. The findings of the regression analysis showed output responses are influenced by both input variables. The results showed that the strength of the samples was significantly influenced by the input parameters. To draw the surface and residual plots, the software of design expert software was used. The interaction between the two input variables suggests raising the extruder temperature and decreasing printing speed, which leads to printing heavier samples. Inversely, the diversity between the forecasted and real responses for the optimal specimens is less than 10% which is assumed to be acceptable for the design of experiments (DOE). The analysis took into account the lower and upper ranges of the input variable with the goal of enhancing both the most modulus and fracture elongation while simultaneously degrading the weight of the specimens. To achieve this objective, the extruder temperature and printing speed are between 240 and 250°C and 65 and 75 mm/s, respectively.