Formation of Shaft Accuracy during Mechanical Processing on CNC Machines

Advances in Science and Technology Pub Date : 2024-04-12 DOI:10.4028/p-n5ukb8

Vagif Abbasov, Fariz Amirov, Samir Amirli, Shalala Hasanli, Karel Frana

引用次数: 0

Abstract

The article discusses the study of the deformation of shafts with a diameter of ø30mm and a length of 400 mm during processing on CNC lathes. Experiments have revealed that during rough turning of the shafts, the magnitude of shaft deformation is 2.2-2.5 times greater compared to finish turning. It has been determined that during processing shafts on a CNC lathe, the maximum deformation is observed near the tailstock side of the machine.

查看原文本刊更多论文

数控机床机械加工过程中轴精度的形成

文章讨论了直径为 ø30 毫米、长度为 400 毫米的轴在数控车床上加工时的变形研究。实验表明，在粗车轴时，轴的变形量是精车轴的 2.2-2.5 倍。据测定，在数控车床上加工轴时，在靠近机床尾座一侧观察到最大变形。

本文章由计算机程序翻译，如有差异，请以英文原文为准。

求助全文

约1分钟内获得全文求助全文

来源期刊

Advances in Science and Technology

自引率

0.00%

发文量