Verification Test and Research on Fitting Curve of Shear and Tensile Synthesis Method

Abstract

Based on the recommended curve of concrete compressive strength tested by shear and tensile composite method, this paper combined with concrete specimens of different strength grades, ages and batches produced by several test verification units, adopted the in vitro shear and tensile test method introduced by the regulations, and used basically the same test equipment to collect the single shear and tensile strength and the compressive strength of cube specimens under the same conditions. Each batch was divided into 15 or 30 specimens. Through the collected test data, the conversion strength of the single shear, pull-out and shear tensile composite methods were calculated respectively. The relative error of a single specimen was calculated based on the average strength of each batch of concrete. The error distribution types and errors of each company were systematically studied, and finally the relative error data of each company were summarized, and the probability distribution parameters of the error of the Shear and tensile synthesis method were understood through probability distribution analysis, and the relationship between the error of the shear and tensile synthesis method, the single shear method and the pull method, and the influence degree on the conversion strength of the shear and tensile synthesis method were shown by using three-dimensional coordinates. Using the test data of "shear and tensile synthesis method", "single shear method" and "pull-out method", the scatter plot is drawn, and the error size is compared to explore the direction of further improving the detection accuracy of "shear and tensile synthesis method".