Polyethylene Glycol as Surface Modification of Magnetite Nanoparticle Coated Silica a Potentially Hyperthermia Therapy Material

Abstract

Local hyperthermia therapy is one of the cancer treatments by implementing heat from a temperature of 41-45°C on cancer cells. This method is believed to reduce the risk of normal cells around the cancer cells from dying. The form of hyperthermia therapy itself is in ferrofluid. During its development, superparamagnetic nanoparticles of iron oxide have attracted various studies because of their good magnetic properties and good biocompatibility. However, the poor particle interactions and their tendency to aggregation make coatings on superparamagnetic necessary. Therefore, silica coating on the superparamagnetic surface is carried out to reduce the risk of aggregation and increase the biocompatibility of the material. Polyethylene glycol functionalization was also applied to improve the biocompatibility of the material, as well as being a carrier for ferrofluid. The test was carried out using the magnetite co-precipitation synthesis method and the formation of a sol-gel silica coating. Variations applied in this experiment are the effects of TEOS concentration as a source of silica and the ratio of particles to PEG. The addition of silica was proven to increase the value of the magnetic moment to 51.55 emu/g. The addition of TEOS as a source of silica in iron (III) nanoparticles has an effect on increasing the magnetic attraction, decreasing the surface tension value, reducing particle size, and decreasing the SAR value. Functionalization of polyethylene glycol has the effect of reducing the magnetic moment, increasing and decreasing hydrophobicity, increasing the surface tension value, and reducing the particle size of iron (III) oxide nanoparticles. This shows that magnetic nanoparticles coated with silica with polyethylene glycol functionalization are proven to generate heat when given AC current with the SAR value and the highest temperature is found in iron (III) oxide which gets 3ml silica coating with a PEG ratio of 2:5 at a temperature of 32.2°C. and SAR value of 87.63 W/mg