Evaluation of characteristics of periodontal probes

Abstract

Aim: This study aimed to evaluate the millimeter distances and active tip diameters of different periodontal probes. Methods: Two types of periodontal probes were analyzed (North Carolina (15-UNC) and PCP-12). Two manufacturers were selected for each probe type. Digital images of the probes were obtained and the distances were measured using a software program. The diameter of the active tip was measured using a digital caliper. Both variables were measured by two trained and calibrated examiners. The data were analyzed using the Bland-Altman method and two-way ANOVA with Tukey’s post-hoc test. Statistical significance was set at p<0.05. Results: A comparison of measurements between the 15UNC and PCP-12 probes showed a significant difference in all millimeter markings. The 15-UNC probe showed differences between the 3 and 12 mm markings. The PCP-12 probe only showed differences between the marks at the 12 mm mark. The 15-UNC probe had a similar active tip diameter between the two manufacturers. The PCP-12 probe showed a significant difference between the two manufacturers. Both types of probes had similar active tip diameters when compared by the two manufacturers. Conclusion: There was no standardization in relation to millimeter marks and tip diameters of the two types of periodontal probes produced by the two different manufacturers. The probe types exhibited little variability.