CUTTING ANALYSIS ON HORIZONTAL DRIILING USING CUTTING CARRY INDEX, CUTTING TRANSPORT RATIO AND CUTTING CONCENTRATION IN ANNULUS METHOD ON A WELL G FIELD S

Abstract

The basic principle of the drilling operation is to grind the rock formations with bits which will later become drill cuttings. In this process, fluid is needed as a conveying medium, commonly known as drilling mud, because the deeper the drilling, the more drill flakes are produced. One of the prominent functions of drilling mud is lifting the drill shale up to surface. The purpose of this analysis is to quantitatively prove whether the cutting has been successfully lifted to the surface or not, and to determine the elements of the fluid’s physical properties and the drilling mud fluid’s rheology. This analysis was carried out using three methods including; the cutting carry index, which the value required is greater than one; the cutting transport ratio, which the value required is greater than 50%; and the cutting concentration in annulus, which the value required is less than 5%. If the value of the quantitative calculation already has a value above the standard, it can be concluded that the drill cuttings can be lifted optimally. The value of the cutting carry index has to be greater than one, because if it is less than one the solid value in the mud is still lacking, causing a low density so it will affect the carrying capacity of cutting in 1 gal of mud. The value of cutting concentration in annulus should not be more than 5, it is feared that if it exceeds this limit, it can affect the rate of penetration and can cause a stuck. As for the value of the cutting transport ratio should not be less than 50% because if it is less than that the hydrostatic pressure below will be large and can cause formation fractures. In this case, we will discuss the analysis of cutting removal on the 8.5 inch route at 4290 to 5174 ft depth, with a slope of 66.29o from the starting point of the borehole.