Determination of the Optimal Design of a Wastewater Treatment Plant after Waterjet Cutting

Q4 Materials Science

Steel in Translation Pub Date : 2023-11-29 DOI:10.3103/s0967091223090036

A. A. Baurov

引用次数: 0

Abstract

The analysis of flotation tanks and the composition of waste water after hydroabrasive cutting has been carried out. The most optimal design of the treatment unit for waste water treatment of a hydroabrasive machine was been determined. The results of studies aimed at determining the main parameters and the principle of operation of a waste water treatment plant for waste water treatment after the hydroabrasive cutting are presented.

Abstract Image

查看原文本刊更多论文

水射流切割后污水处理厂优化设计的确定

摘要对浮选槽进行了水磨料切削后的废水成分分析。确定了水磨料机废水处理装置的最优设计方案。介绍了水磨料切削后废水处理装置的主要参数和运行原理的研究结果。

本文章由计算机程序翻译，如有差异，请以英文原文为准。

求助全文

约1分钟内获得全文求助全文

来源期刊

Steel in Translation Materials Science-Materials Science (all)

CiteScore

0.60

自引率

0.00%

发文量

期刊介绍： Steel in Translation is a journal that represents a selection of translated articles from two Russian metallurgical journals: Stal’ and Izvestiya Vysshikh Uchebnykh Zavedenii. Chernaya Metallurgiya . Steel in Translation covers new developments in blast furnaces, steelmaking, rolled products, tubes, and metal manufacturing as well as unconventional methods of metallurgy and conservation of resources. Papers in materials science and relevant commercial applications make up a considerable portion of the journal’s contents. There is an emphasis on metal quality and cost effectiveness of metal production and treatment.