Microstructure investigation of cast irons with nodular and flake graphite via nanoindentation

IF 0.7 Q3 ENGINEERING, MULTIDISCIPLINARY

Engineering Review Pub Date : 2023-01-01 DOI:10.30765/er.1861

Peter Petruš, Igor Barényi, Jozef Majerík

引用次数: 0

Abstract

The paper investigates and compares the local mechanical properties of microstructure components in grey iron EN GJL -300 and ductile iron EN GJS -500-7. The microstructure of both cast irons is analysed by LOM, and then certain microstructure components found and their local mechanical properties are investigated. Finally, the resulting nanohardness and reduced Young modulus of the components are discussed and compared between the two cast irons used. A Hysitron TI -950 gauge with Triboscan software is used to perform experiment measurements.

查看原文本刊更多论文

用纳米压痕法研究球墨和片状石墨铸铁的显微组织

研究并比较了灰口铸铁EN GJL -300和球墨铸铁EN GJS -500-7微观组织构件的局部力学性能。利用LOM分析了两种铸铁的显微组织，发现了特定的显微组织成分，并对其局部力学性能进行了研究。最后，讨论并比较了两种铸铁的纳米硬度和杨氏模量。使用hyysitron TI -950测量仪和Triboscan软件进行实验测量。

本文章由计算机程序翻译，如有差异，请以英文原文为准。

求助全文

约1分钟内获得全文求助全文

来源期刊

Engineering Review ENGINEERING, MULTIDISCIPLINARY-

CiteScore

1.00

自引率

0.00%

发文量

期刊介绍： Engineering Review is an international journal designed to foster the exchange of ideas and transfer of knowledge between scientists and engineers involved in various engineering sciences that deal with investigations related to design, materials, technology, maintenance and manufacturing processes. It is not limited to the specific details of science and engineering but is instead devoted to a very wide range of subfields in the engineering sciences. It provides an appropriate resort for publishing the papers covering prior applications – based on the research topics comprising the entire engineering spectrum. Topics of particular interest thus include: mechanical engineering, naval architecture and marine engineering, fundamental engineering sciences, electrical engineering, computer sciences and civil engineering. Manuscripts addressing other issues may also be considered if they relate to engineering oriented subjects. The contributions, which may be analytical, numerical or experimental, should be of significance to the progress of mentioned topics. Papers that are merely illustrations of established principles or procedures generally will not be accepted. Occasionally, the magazine is ready to publish high-quality-selected papers from the conference after being renovated, expanded and written in accordance with the rules of the magazine. The high standard of excellence for any of published papers will be ensured by peer-review procedure. The journal takes into consideration only original scientific papers.