Preparation, morphology and thermoelectric performance of PEDOT/CuI nanocomposites

Abstract

Incorporating inorganic nanomaterials into a polymer matrix is one of the most effective ways to create thermoelectric performance for applications where physical flexibility is essential. In this study, flexible thermoelectric nanocomposite films were synthesized by incorporating inorganic copper iodide (CuI) nanosheets as the filler into poly (3,4-ethylene dioxythiophene): poly (styrene sulfonate) (PEDOT: PSS). The process involved the preparation of bulk CuI from precursors and, subsequently, the nanosheet synthesis by dissolving the bulk CuI in dimethyl sulfoxide (DMSO). The morphology of the nanosheets and the nanocomposite films was thoroughly examined, and the film’s thermoelectric performance was evaluated using a standard thermoelectric measurement system, ZEM-3. The morphological observation revealed a triangular nanosheet geometry for CuI, with an average lateral dimension of ~33 nm. The PEDOT/CuI nanocomposite films were prepared by mixing CuI nanosheets with PEDOT: PSS through ultrasonication and filtration on a PVDF membrane. The film with 6.9 vol% of CuI nanosheets exhibited an electrical conductivity and Seebeck coefficient of 852.07 S·cm^-1 and 14.95 µV·K^-1, respectively. This resulted in an enhanced power factor of 19.04 µW·m^-1·K^-2, much higher than the individual composite components. It demonstrated a trend of increasing power factor with the nanosheets up to 6.9 vol% due to improved electrical conductivity. The increase in electrical conductivity can be attributed to the screening effect induced by DMSO, which leads to a conformational change in the PEDOT chains. Furthermore, an optimal fraction of CuI nanosheets also contributes to this conformational change, further enhancing the electrical conductivity.

Graphical Abstract