Modeling supercontinuum generation in microstructured fibers by femtosecond pump pulses using Split-Step Fourier method

2012 35th International Spring Seminar on Electronics Technology Pub Date : 2012-05-09 DOI:10.1109/ISSE.2012.6273092

Y. Bashkatov, B. Tsyganok, V. Khomenko, N. Kachalova, V. Voitsekhovich, I. Uvarova

引用次数: 3

Abstract

Numerical algorithm for modeling supercontinuum generation was build. Split-step Fourier method was used modeling. Dependence on pump wavelength is shown. Modeling is implemented in MatLab environment. All results of theoretical modulation are proved by experiment.

查看原文本刊更多论文

用分步傅里叶方法模拟微结构光纤中飞秒泵浦脉冲产生的超连续谱

建立了模拟超连续谱生成的数值算法。采用分步傅立叶方法进行建模。显示了对泵浦波长的依赖性。建模在MatLab环境下实现。实验验证了理论调制的结果。

本文章由计算机程序翻译，如有差异，请以英文原文为准。

求助全文

约1分钟内获得全文求助全文

来源期刊

2012 35th International Spring Seminar on Electronics Technology

自引率

0.00%

发文量