Method for determining the parameters of the front loader electromechanical transmission

Abstract

A method for calculating the traction motor of a hybrid transmission of a front-end loader is pro-posed. It is indicated that these vehicles are characterized by a mode of operation with multiple ac-celerations and decelerations, as well as alternating operations with high and low required traction force. An electromechanical transmission scheme is proposed. This scheme can be effectively used in such conditions. The proposed method uses the concept of the magnitude of the range of an electric motor, which can be used to select a specific electric motor that provides the required mobility of the vehicle. For a front loader with a lifting capacity of 3500 kg, a maximum speed of 40 km / h and a maximum specific thrust of 1, the main parameters of the traction motor were determined. However, for the transmission with one fixed gear ratio (EMT1), an electric motor with an excessively high power was obtained. Therefore, the determination of the characteristics of the electric motor for an elec-tromechanical transmission with two fixed gear ratios (EMT2) was carried out. In the process of calculating this transmission, a significantly lower required engine power was obtained. The article provides an approximate assessment of the energy efficiency of EMT1 and EMT2 transmissions. A method to determine the efficiency of an electric motor depending on its operating mode (on the current angular speed of the shaft and torque) was used. It was determined that the EMT2 transmission has the best efficiency of the electric motor both during bulldozing operation and when driving at maximum speed. The general conclusion is that it is most rational to use a transmission with two fixed gear ratios. As a further direction of research, the use of computer simulation for evaluating the energy efficien-cy of a loader in a loading-unloading cycle is highlighted.