Comparison of laboratory measurements on an EDFA with simulation results obtained using EDFA-Design

Proceedings of 2001 3rd International Conference on Transparent Optical Networks (IEEE Cat. No.01EX488) Pub Date : 2001-06-18 DOI:10.1109/ICTON.2001.934777

T.P. Baraniecki, M. Kozak, U.B. Unrau, E. Pawlik, K. Abramski

引用次数: 1

Abstract

A comparison of measurements and simulations on an erbium-doped fiber amplifier (EDFA) is given. A commercial program (EDFA-Design(R)) was used for the simulations. Measurement results were obtained during the MSc. project of the corresponding author in the Institute of Telecommunications and Acoustics in Wroclaw University of Technology. The basic characteristics of the EDFA and the operation of the EDFA in a simple WDM system were checked.

查看原文本刊更多论文

EDFA的实验室测量值与EDFA- design模拟结果的比较

对一种掺铒光纤放大器(EDFA)进行了测量和仿真比较。采用商业软件EDFA-Design(R)进行仿真。测量结果在MSc期间获得。通讯作者在弗罗茨瓦夫工业大学电信与声学研究所的项目。研究了EDFA的基本特性和在简单波分复用系统中的工作情况。

本文章由计算机程序翻译，如有差异，请以英文原文为准。

求助全文

约1分钟内获得全文求助全文

来源期刊

Proceedings of 2001 3rd International Conference on Transparent Optical Networks (IEEE Cat. No.01EX488)

自引率

0.00%

发文量