Composting of fine fraction after mechanical-biological treatment of municipal solid waste

One of most common types of municipal solid waste treatment is mechanical-biological treatment (MBT), which in practice has many variations depending on the method of conducting the technological process and it is possible to get different output fractions. In this paper is analysed waste generated after the MBT with biodrying, where waste after mechanical treatment undergoes process of biodrying, and then is RDF (recovery derived fuel) separated. Fine fraction remains with a high content of organic matter that without additional processing cannot be disposed of on a landfill. The aim of this research was to determine the possibility of fine fraction composting in different conditions – in the open, in the open and covered area, and indoors. In each area are formed three compost piles: 100% fine fraction (KH1, KH4, and KH7), 70% fine fraction and 30% wood chips (KH2, KH5, and KH8), 50% fine fraction and 50% wood chips (KH3, KH6, and KH9). Moisture content, temperature and dissolved organic carbon (DOC) were monitored. Results show that after 13 weeks samples KH1, KH4, and KH7 (100% content of fine fractions) did not achieve DOC value less than 3 000 mg/l. The most effective composting in terms of reducing the DOC is achieved in samples KH3, KH6, KH9. Based on results obtained, it can be concluded that by adding wood chips in fine fraction in ratio 50:50, the most effective and fastest reduction of organic matter is achieved in the analysed samples.