Catalytic quality improvement of waste polyolefin originated fractions

Abstract The demand for alternative fuels having low greenhouse gases emission is continuously growing worldwide. Therefore it is preferred to produce new, waste originated components. One option is the recycling of plastic waste with cracking. The produced hydrocarbon fraction is not suitable for fuels thus it is important to improve its quality. The aim of our experimental work was to study the quality improvement of this cracked fraction (PPCGO) and crude oil based middle distillates (different composition) with co-processing. Our goal was to produce high quality diesel fuel blending components. We studied the effect of process parameters on the quality of products. Ni (2.3%) Mo (11.0%) P (2.3%)/Al2O3 catalyst was used. During the experiments we studied the hydrogenation of olefins, saturation of aromatics and desulphurization. The hydrogenation of olefins was practically complete at 300°C. It took place at significantly higher speed than the desulphurization reactions. In case of light gas oil feedstock the products had significantly lower sulphur contents; below 10 mg/kg already at 340°C. We determined that the cracked fraction had beneficial effect on the performance properties of the products. In case of all feedstock combinations, we found process parameters which can be used to produce high-quality diesel fuel blending components on the tested catalyst.