The cathode array effects on features and reproducibility of emitted hard x-rays, and anode erosion in a small plasma focus device

Using a small (450 J) Mather-type plasma focus device, this research investigates the effects of cathode rod removal from the cathode array in two steps on hard x-ray emission, both in total and specifically from the plasmoid. The effect on anode rod erosion is also measured. Six hard x-ray detectors were placed around the chamber to measure the emitted hard x-rays. By reducing the number of cathode rods, some features of these hard x-rays such as peak intensity and pulse yield decreased and were deteriorated. Besides, the capability of the device for producing and reproducing the hard x-rays with roughly similar and repeatable characteristics diminished. Moreover, the anode erosion took place during the breakdown phase and by using the detectors around the chamber, similar features were obtained both for the total and the plasmoid hard x-rays, but with different scales. The cathode rod removal could violate the symmetry and uniform formation of the current sheath layer during the breakdown phase and could weaken and change the direction of the Lorentz force vector acting on the current sheath layer during the axial phase. It also causes discharge delay and decreases the axial and radial velocities of the current sheath layer which would result in a weak pinch effect and reduced number of energetic runaway electrons inside the plasma column during the pinch phase. These electrons, by colliding the anode surface, are mainly responsible for producing the great portion of the emitted hard x-ray. On the contrary and based on a different mechanism, the cathode rod removal enhances the number of the runaway electrons during the breakdown phase which increases the anode erosion and enhances the impurities that eventually leads to a weak emission of low intensity hard x-rays.