DNA-labeled chitosan nanoparticles: A potential new surrogate for assessing rotavirus attenuation and transport in sand filtration water treatment

Despite being a model in waterborne risk assessment, rotavirus attenuation and transport in sand filtration water treatment remains poorly understood due to a lack of representative surrogates. We investigated the suitability of DNA-labeled chitosan nanoparticles (DCNPs) to mimic rotavirus attenuation and transport in coastal and alluvial sands. Chitosan nanoparticles were synthesized and coupled with a DNA tracer. Compared to rotavirus, DCNPs had similar size (79 ± 7.2 nm vs. 72.5 nm) and buoyant density (1.65 ± 0.07 g/cm³ vs. 1.36–1.40 g/cm³) but a less negative zeta potential (−20.61 ± 1.94 mV vs. −29.77 ± 0.86 mV) and lower hydrophobicity (0% vs. 44%). Filtration experiments (flow rate 1.26–1.27 ml/min, pH 6.0, electrical conductivity 224–226 μs/cm) showed that DCNPs approximated rotavirus attenuation in coastal and alluvial sands (p ≥ 0.07). Repeated dosing of rotavirus and DCNPs caused removal efficiencies to decline in the sand media. Both entities displayed faster and less dispersive transport than a nonreactive solute tracer (NaCl) in sand media. This preliminary study suggested that DCNPs can approximately mimic rotavirus attenuation and transport in coastal and alluvial sands. However, further validation under diverse experimental conditions is necessary. This includes varying flow rates, pH levels, ionic strengths, and the presence of multivalent cations (e.g., Ca²⁺ and Mg²⁺) and organic matter. DCNPs, made from a nontoxic, biocompatible, and biodegradable natural biopolymer, hold promise as a safe tool for assessing rotavirus attenuation and transport in sand filtration water treatment and aquifer filtration processes.