Effect of laser irradiation during in-office tooth bleaching on surface properties of resin-based restorative materials

This study evaluated the changes in surface properties of three resin-based restorative materials after two laser-assisted, in-office tooth bleaching protocols using erbium, chromium: yttrium-scandium-gallium-garnet (Er,Cr:YSGG) or diode (980 nm) lasers. A nanohybrid composite (Enamel Plus HRi), a Bis-GMA-free composite (Enamel Plus HRi Bio Function), and a resin-matrix CAD-CAM ceramic (Shofu Block HC) were tested. Forty specimens for each material were prepared and divided into four groups (n = 10/group). The control specimens did not undergo any bleaching treatment, whereas group 2 received bleaching with 40% hydrogen peroxide (H₂O₂), while groups 3 and 4 underwent the same bleaching procedure with the use of diode (980 nm) or Er,Cr:YSGG lasers, respectively. Surface microhardness and roughness measurements were conducted using a Vickers tester and an optical profilometer. Microhardness was lower in bleached specimens, with the nanohybrid composite exhibiting the largest difference from the no bleaching group. For the Bis-GMA-free composite the microhardness difference between no bleaching and laser-assisted bleaching were smaller than seen for the conventional bleaching technique. Surface roughness was higher in bleached specimens, with nanohybrid composite showing the largest differences from the control specimens. The examined laser-assisted tooth bleaching protocols were found not to impact surface microhardness and roughness of the tested resin-based specimens and they are deemed suitable for clinical use.