The Rice Straw Tying Device Parameters Using UG Software to Establish Three-Dimensional Model of Rice Harvest Tying Device Baling Machine

With the improvement of the utilization rate of straws, the recovery question of rice straw has been focused. In the past, the recovery of rice straw needs a lot of manpower. also need to be equipped with a vehicle, most of bundling machine were traction type bundling machine in domestic, secretary was inefficient, this greatly increases the cost of recycling, and the recovery of straw caused two compactions of soil, so that farmers will burn a lot of straw, cause pollution of the environment. Therefore, this study is based on the whole feeding rice combine harvester. added the straw bale device, One-time finished the rice harvesting, threshing cleaning and warehousing and Rice straw compression, bale and other processes. Improve the recovery efficiency of rice straw, reduce the cost of straw recovery, reduced the number of mechanicals going in the fields. In this paper using UG software for the rice harvest tying device baling machine 3 d drawing, and carries on the kinematics simulation, the simulation for bundling device compression mechanism motion state laws.