Surface studies with a gloss meter

Q3 Engineering

Mocaxue Xuebao/Tribology Pub Date : 1974-04-01 DOI:10.1016/0041-2678(74)90037-2

S.K. Vashisht, V. Radhakrishnan

引用次数: 10

Abstract

The gloss of a manufactured surface can be used as a measure for its roughness. This method has the advantage that it is a non-contact measurement and refers to the three dimensional surface. Although this method has been known for a long time, it is currently being tried out for eventual roughness measurements for the adaptive control of machine tools. Various factors affecting the gloss and its relationship with the conventional roughness values are given.

查看原文本刊更多论文

用光泽度计进行表面研究

加工表面的光泽度可用来衡量其粗糙度。这种方法的优点是它是一种非接触式测量，并且是指三维表面。虽然这种方法已经知道了很长一段时间，但它目前正在尝试用于机床自适应控制的最终粗糙度测量。给出了影响光泽度的各种因素及其与常规粗糙度值的关系。

本文章由计算机程序翻译，如有差异，请以英文原文为准。

求助全文

约1分钟内获得全文求助全文

来源期刊

Mocaxue Xuebao/Tribology Engineering-Mechanical Engineering

CiteScore

1.90

自引率

0.00%

发文量

3489

期刊介绍： As the most authoritative comprehensive science periodical covering all branches of Tribology in China, “Tribology” deals with various academic, technological, and engineering topics in the interdisciplinary subjects of Mechanical Science and Technology, Materials Science and Engineering, Physics, Chemistry, Mechanics, etc. It covers new achievements in the fundamental, applied fundamental, and applied researches in Tribology, reflects the development and direction of Tribology at home and abroad, helps to find and train young scholars, speeds up extensive academic exchange, promotes the development of Tribology subject, and serves for the development of economy and society.