Preparation of flexible porous γ-Al2O3 nanofibers by electrospinning and its application in supercapacitor separator

Abstract

In this paper, a 150-µm-thick flexible γ-Al₂O₃ nanofiber separator with the tensile strength of 0.22 MPa was prepared from the low-cost aluminum chloride hydroxide/polyvinyl alcohol (PVA)/water precursor materials by electrospinning method. The resultant separator with 3D interconnection nanostructure revealed fiber diameters in the range of 200 to 500 nm. The specific surface area, porosity, and electrolyte uptake of γ-Al₂O₃ nanofiber separator are 31.5 m²/g, 55%, and 1021%, higher than that of commercial polypropylene (PP) separator and glass fiber (GF) separator. The supercapacitor assembled with the γ-Al₂O₃ nanofiber separator exhibited a high discharge specific capacitance of 93 F/g at the current density of 1A/g, and there is almost no capacity decay after 10,000 cycles. The energy density of supercapacitor assembled with γ-Al₂O₃ nanofiber separator is 31.7 Wh/kg at the power density of 562.6 W/kg. Meanwhile, the rate performance of the supercapacitor is improved significantly due to the existence of porous structure and low ion diffusion resistance (0.78 Ω) of γ-Al₂O₃ nanofiber separator. In addition, the thermal performance of the γ-Al₂O₃ nanofiber separator is also excellent, which has almost no shrinkage at the temperature of 200 °C and cannot be ignited. Therefore, the obtained γ-Al₂O₃ nanofibers could serve as a promising alternative separator for a new generation of safe, high-power supercapacitors.