Quantitative detection of axial defects in pipelines based on modified multi-mode total focusing method (MTFM)

Abstract

The axial defects in pipelines are hard to detect effectively with the conventional multi-mode total focusing method (MTFM). The inner and outer curved surfaces of pipelines induce beam divergence, reducing focusing performance and introducing imaging distortion and errors. In this paper, the MTFM employed for inspecting flat plates is modified in consideration of the influences of pipe curvature on the ray paths of direct, half-skip and full-skip mode waves. The corresponding travel times are recalculated and used for performing delay-and-sum (DAS) beamforming, achieving the profile reconstruction and quantitative detection of axial defects. The simulation and experiments were implemented on the carbon steel pipeline with 100 mm outer radius and 20 mm wall thickness. The phased array (PA) probe with 32 elements and 5 MHz central frequency and the 55° curved wedge were adopted to detect the inner-wall axial defects in pipeline. The profiles of the planar defects with a length of 5 mm and orientation angles of −45°∼45° were well reconstructed by modified MTFM, and the measurement errors of flaw lengths, orientation angles and tip depths were no more than 16.6 %, 5.1° and 4.0 % after correction, respectively. Further simulated and experimental results indicate that the internal axial defects can also be detected and quantified by modified MTFM. Finally, the influences of pipe curvature on modified MTFM are discussed by simulation.