Performance improvement of multilayered ZnO/SnO2 thin-film transistors by varying supercycles and growth temperatures

IF 1.4 4区 物理与天体物理 Q3 ENGINEERING, ELECTRICAL & ELECTRONIC
Chan-Yeong Park, Se-Hyeong Lee, So-Young Bak, Dongki Baek, Hyeongrok Jang, Jinwoo Lee, Moonsuk Yi
{"title":"Performance improvement of multilayered ZnO/SnO2 thin-film transistors by varying supercycles and growth temperatures","authors":"Chan-Yeong Park,&nbsp;Se-Hyeong Lee,&nbsp;So-Young Bak,&nbsp;Dongki Baek,&nbsp;Hyeongrok Jang,&nbsp;Jinwoo Lee,&nbsp;Moonsuk Yi","doi":"10.1016/j.sse.2024.108920","DOIUrl":null,"url":null,"abstract":"<div><p>The performance of conventional ZnSnO (ZTO) amorphous oxide semiconductor thin-film transistors deposited by atomic layer deposition was optimized at annealing temperatures greater than 500 °C, which is higher than the application temperature of flexible substrates (400 °C). Therefore, we deposited a ZTO thin film as a multilayered ZnO/SnO<sub>2</sub> structure to lower the process temperature to below 400 °C. To optimize the performance of the device with a multilayered structure, we examined the effects of cycles and growth temperatures. Finally, after performing 6 supercycles with 10 cycles of ZnO and 20 cycles of SnO<sub>2</sub>, at a growth temperature of 180 °C and annealing at 350 °C for 1 h, the device achieved a saturation carrier mobility of 8.09 cm<sup>2</sup>/V·s, threshold voltage of 1.6 V, subthreshold swing of 0.58 V/dec, and on–off current ratio of 2.63 × 10<sup>7</sup>. The optimized multilayer-structured device performed better than the ZTO device annealed at 350 °C for 1 h, and even outperformed the device annealed at 500 °C for 1 h. X-ray photoelectron spectroscopy analysis was also conducted to analyze the properties of conventional ZTO and multilayered ZnO/SnO<sub>2</sub> thin films.</p></div>","PeriodicalId":21909,"journal":{"name":"Solid-state Electronics","volume":"216 ","pages":"Article 108920"},"PeriodicalIF":1.4000,"publicationDate":"2024-03-30","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"0","resultStr":null,"platform":"Semanticscholar","paperid":null,"PeriodicalName":"Solid-state Electronics","FirstCategoryId":"101","ListUrlMain":"https://www.sciencedirect.com/science/article/pii/S0038110124000698","RegionNum":4,"RegionCategory":"物理与天体物理","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q3","JCRName":"ENGINEERING, ELECTRICAL & ELECTRONIC","Score":null,"Total":0}
引用次数: 0

Abstract

The performance of conventional ZnSnO (ZTO) amorphous oxide semiconductor thin-film transistors deposited by atomic layer deposition was optimized at annealing temperatures greater than 500 °C, which is higher than the application temperature of flexible substrates (400 °C). Therefore, we deposited a ZTO thin film as a multilayered ZnO/SnO2 structure to lower the process temperature to below 400 °C. To optimize the performance of the device with a multilayered structure, we examined the effects of cycles and growth temperatures. Finally, after performing 6 supercycles with 10 cycles of ZnO and 20 cycles of SnO2, at a growth temperature of 180 °C and annealing at 350 °C for 1 h, the device achieved a saturation carrier mobility of 8.09 cm2/V·s, threshold voltage of 1.6 V, subthreshold swing of 0.58 V/dec, and on–off current ratio of 2.63 × 107. The optimized multilayer-structured device performed better than the ZTO device annealed at 350 °C for 1 h, and even outperformed the device annealed at 500 °C for 1 h. X-ray photoelectron spectroscopy analysis was also conducted to analyze the properties of conventional ZTO and multilayered ZnO/SnO2 thin films.

通过改变超循环和生长温度提高多层 ZnO/SnO2 薄膜晶体管的性能
通过原子层沉积法沉积的传统 ZnSnO(ZTO)非晶氧化物半导体薄膜晶体管在退火温度超过 500 ℃ 时性能达到最佳,而这一温度高于柔性衬底的应用温度(400 ℃)。因此,我们将 ZTO 薄膜沉积为多层 ZnO/SnO2 结构,将工艺温度降至 400 °C 以下。为了优化多层结构器件的性能,我们研究了循环和生长温度的影响。最后,在生长温度为 180 ℃、退火温度为 350 ℃ 1 小时的条件下,ZnO 和 SnO2 分别进行了 10 次和 20 次的 6 次超级循环,器件的饱和载流子迁移率达到了 8.09 cm2/V-s,阈值电压为 1.6 V,阈下摆幅为 0.58 V/dec,导通-关断电流比为 2.63 × 107。优化的多层结构器件的性能优于在 350 °C 下退火 1 小时的 ZTO 器件,甚至超过了在 500 °C 下退火 1 小时的器件。
本文章由计算机程序翻译,如有差异,请以英文原文为准。
求助全文
约1分钟内获得全文 求助全文
来源期刊
Solid-state Electronics
Solid-state Electronics 物理-工程:电子与电气
CiteScore
3.00
自引率
5.90%
发文量
212
审稿时长
3 months
期刊介绍: It is the aim of this journal to bring together in one publication outstanding papers reporting new and original work in the following areas: (1) applications of solid-state physics and technology to electronics and optoelectronics, including theory and device design; (2) optical, electrical, morphological characterization techniques and parameter extraction of devices; (3) fabrication of semiconductor devices, and also device-related materials growth, measurement and evaluation; (4) the physics and modeling of submicron and nanoscale microelectronic and optoelectronic devices, including processing, measurement, and performance evaluation; (5) applications of numerical methods to the modeling and simulation of solid-state devices and processes; and (6) nanoscale electronic and optoelectronic devices, photovoltaics, sensors, and MEMS based on semiconductor and alternative electronic materials; (7) synthesis and electrooptical properties of materials for novel devices.
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
确定
请完成安全验证×
copy
已复制链接
快去分享给好友吧!
我知道了
右上角分享
点击右上角分享
0
联系我们:info@booksci.cn Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。 Copyright © 2023 布克学术 All rights reserved.
京ICP备2023020795号-1
ghs 京公网安备 11010802042870号
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术官方微信