Topographical Analysis of Human Enamel after Phosphoric Acid Etching and Er,Cr:YSGG Laser Irradiation.

Abstract

Introduction: Dental hard and soft tissues have been successfully removed by using the Er,Cr:YSGG laser, but there is a controversy about using lasers over conventional tooth surface preparation for bonding aesthetic restoration. Surface roughness and wettability in response to Er,Cr:YSGG laser irradiation are essential properties for restoration longevity. Methods: Fifty-one intact human premolars removed in orthodontic treatment were included in this study and divided into three groups (n=17). The first group (G1) was the control without surface treatment, (G2) was treated with 37% phosphoric acid for 15 seconds, and (G3) was treated with the Er,Cr:YSGG laser using the following parameters: 2 W or 3 W at 20 Hz, 10% air and water ratio using the MZ6 laser tip. The standardization of laser irradiation was accomplished by a computerized numerical control unit. The surface of the samples was evaluated by using a light microscope, profilometer, atomic force microscopy (AFM), SEM, and wettability tests. Results: The SEM examination revealed that the lased enamel surface was clean, irregular, and devoid of a smear layer, while the acid etch surface was relatively smooth and covered with a smear layer. The surface roughness of the lased enamel surface was significantly higher than that of other groups, according to the results of the profilometer as well as the AFM tests. The wettability test showed that the lased enamel surface recorded a significant reduction in the contact angle in comparison to the other groups. Conclusion: It can be concluded that the Er,Cr:YSGG laser can be used as an alternative and safe method to the acid-etching technique for surface treatment.