Stress and deformation states in single-coil inductors used for pipe calibration by means of electrodynamic method

IF 1.2 Q3 ENGINEERING, MECHANICAL

Archive of Mechanical Engineering Pub Date : 2023-11-06 DOI:10.24425/ame.2007.131562

J. Bednarczyk

引用次数: 0

Abstract

The article presents results of tests performed at the AGH-University of Science and Technology in Cracow on strength of single-coil inductors used as tools in electrodynamic machining of pipes. The character of volumetric Lorentz forces acting on coils of compressing and expanding inductors was discussed, and numerically determined distributions of stresses and displacements created in coils under the impact of these forces were presented. The problems presented are relevant when designing durable inductors intended for industrial applications.

查看原文本刊更多论文

用电动力学方法标定管道用单线圈电感的应力和变形状态

本文介绍了在克拉科夫agh科技大学进行的用于管道电动加工工具的单线圈电感器强度测试的结果。讨论了作用在压缩和膨胀电感线圈上的体积洛伦兹力的特性，给出了在这些力作用下线圈内产生的应力和位移的数值计算分布。提出的问题是相关的，当设计耐用的电感用于工业应用。

本文章由计算机程序翻译，如有差异，请以英文原文为准。

求助全文

约1分钟内获得全文求助全文

来源期刊

Archive of Mechanical Engineering ENGINEERING, MECHANICAL-

CiteScore

1.70

自引率

14.30%

发文量

审稿时长

15 weeks

期刊介绍： Archive of Mechanical Engineering is an international journal publishing works of wide significance, originality and relevance in most branches of mechanical engineering. The journal is peer-reviewed and is published both in electronic and printed form. Archive of Mechanical Engineering publishes original papers which have not been previously published in other journal, and are not being prepared for publication elsewhere. The publisher will not be held legally responsible should there be any claims for compensation. The journal accepts papers in English.