Modeling and testing of gear driver with roller bearings

IF 1.2 Q3 ENGINEERING, MECHANICAL

Archive of Mechanical Engineering Pub Date : 2023-11-06 DOI:10.24425/ame.2007.131546

Vytautas Barzdaitis, Vytautas Zemaitis, Pranas Mazeika, Rimantas Didziokas

引用次数: 0

Abstract

Technical system for condition monitoring and failure diagnostics of gear driver with roller bearings was tested in situ. The experimental measurement data of rotors shaft vibration displacements were introduced into physical model of gear teeth meshing dynamics. The modelling and simulation of teeth failures in gear driver with roller bearings was performed by ﬁnite element method. The experimental and simulation results were used in identiﬁcation and elimination of sources of gear teeth damages and bearings failures.

查看原文本刊更多论文

滚子轴承齿轮传动的建模与试验

本文章由计算机程序翻译，如有差异，请以英文原文为准。

求助全文

约1分钟内获得全文求助全文

来源期刊

Archive of Mechanical Engineering ENGINEERING, MECHANICAL-

CiteScore

1.70

自引率

14.30%

发文量

审稿时长

15 weeks

期刊介绍： Archive of Mechanical Engineering is an international journal publishing works of wide significance, originality and relevance in most branches of mechanical engineering. The journal is peer-reviewed and is published both in electronic and printed form. Archive of Mechanical Engineering publishes original papers which have not been previously published in other journal, and are not being prepared for publication elsewhere. The publisher will not be held legally responsible should there be any claims for compensation. The journal accepts papers in English.